MAX4163ESA+T Maxim Integrated Products, MAX4163ESA+T Datasheet
MAX4163ESA+T
Specifications of MAX4163ESA+T
Related parts for MAX4163ESA+T
MAX4163ESA+T Summary of contents
Page 1
... Pin Configurations continued at end of data sheet. UCSP is a trademark and µMAX is a registered trademark of Maxim Integrated Products, Inc. ________________________________________________________________ Maxim Integrated Products For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com. Rail-to-Rail I/O Op Amps o UCSP Package (MAX4163 ...
Page 2
UCSP, Micropower, Single-Supply, 10V, Rail-to-Rail I/O Op Amps ABSOLUTE MAXIMUM RATINGS Supply Voltage ( ..................................................11V DD SS IN+, IN-, OUT Voltage ......................(V DD Short-Circuit Duration (to either rail)...........................Continuous Continuous Power Dissipation (T = +70°C) A 5-Pin SOT23 ...
Page 3
UCSP, Micropower, Single-Supply, 10V, ELECTRICAL CHARACTERISTICS: 3V Operation (continued OUT ues are +25°C.) (Note 1) A PARAMETER SYMBOL Input Voltage-Noise Density e ...
Page 4
UCSP, Micropower, Single-Supply, 10V, Rail-to-Rail I/O Op Amps ELECTRICAL CHARACTERISTICS: 5V Operation (continued OUT values are +25°C.) (Note 1) A PARAMETER SYMBOL ...
Page 5
UCSP, Micropower, Single-Supply, 10V +25°C, unless otherwise noted INPUT OFFSET VOLTAGE vs. TEMPERATURE 1000 750 500 250 0 -250 -500 -750 -1000 -40 ...
Page 6
UCSP, Micropower, Single-Supply, 10V, Rail-to-Rail I/O Op Amps ( MAXIMUM OUTPUT VOLTAGE vs. LOAD CURRENT 300 LOAD TO V ...
Page 7
UCSP, Micropower, Single-Supply, 10V +25°C, unless otherwise noted TOTAL HARMONIC DISTORTION PLUS NOISE vs. OUTPUT VOLTAGE SWING ...
Page 8
UCSP, Micropower, Single-Supply, 10V, Rail-to-Rail I/O Op Amps ( +25°C, unless otherwise noted NONINVERTING SMALL-SIGNAL PULSE RESPONSE ( ...
Page 9
UCSP, Micropower, Single-Supply, 10V +25°C, unless otherwise noted NONINVERTING LARGE-SIGNAL PULSE RESPONSE ( 2V/div OUT 2V/div ...
Page 10
UCSP, Micropower, Single-Supply, 10V, Rail-to-Rail I/O Op Amps a) RAIL-TO-RAIL INPUT/OUTPUT VOLTAGE RANGE ( 1V/div OUT 1V/div 200µs/div 1kHz 10kΩ DD P-P L Figure 1. Rail-to-Rail ...
Page 11
UCSP, Micropower, Single-Supply, 10V, 1) The on-board charge pumps generate a small amount of 700kHz switching noise at the op amp’s output. The amplitude of this noise is typically 100µV . The noise is not referred to the input, and ...
Page 12
UCSP, Micropower, Single-Supply, 10V, Rail-to-Rail I/O Op Amps a) POWER-UP TRANSIENT ( 1.5V/div OUT 750mV/div 100µs/div 10kΩ Figure 3. Power-Up Transient: ...
Page 13
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 ____________________ 13 © 2010 Maxim Integrated Products ...