DS1834DS+ Maxim Integrated Products, DS1834DS+ Datasheet - Page 3

• Manufacturer Part Number: DS1834DS+
• Description: IC ECONORST DUAL ACT HI PP 8SOIC
• Manufacturer: Maxim Integrated Products
• Series: EconoResetr
• Type: Multi-Voltage Supervisorr

Specifications of DS1834DS+

• Number Of Voltages Monitored: 2
• Output: Push-Pull, Totem Pole
• Reset: Active High
• Reset Timeout: 200 ms Minimum
• Voltage - Threshold: 3.3V, 5V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DS1834/A/D
Tolerance Select
The DS1834 provides two TOL inputs for individual customization of the DS1834 to specific application
requirements. If the TOL for the 5-volt supply is tied to the 5-volt input a 10% tolerance is selected for
the 5 volt supply. If the TOL for the 3.3-volt supply is tied to the 3.3-volt input, a 20% tolerance is
selected for the 3.3-volt supply. If TOL inputs are tied to ground, the 5-volt input will be set at a 5%
tolerance and the 3.3-volt input would be set to a 10% tolerance.
Pushbutton Reset
The DS1834 provides a pushbutton switch for manual reset control. When at least one of the DS1834
resets are not in a reset cycle, a pushbutton reset can be generated by pulling the
pin low for at
PBRST
least 2 ms. When the pushbutton is held low, both resets are forced active and will remain active for about
350 ms after the pushbutton is released. The pushbutton input is pulled high through an internal
40 k =pull-up resistor and debounced via internal circuitry. See Figure 3 for an application example and
Figure 4 for the timing diagram.
PUSHBUTTON RESET Figure 3
TIMING DIAGRAM: PUSHBUTTON RESET Figure 4
3 of 7