TC1186-3.0VCT713 Microchip Technology, TC1186-3.0VCT713 Datasheet - Page 8

• Manufacturer Part Number: TC1186-3.0VCT713
• Description: IC CMOS LDO 3.0V 150MA SOT23A-5
• Manufacturer: Microchip Technology

Specifications of TC1186-3.0VCT713

• Regulator Topology: Positive Fixed
• Voltage - Output: 3V
• Voltage - Input: Up to 6V
• Voltage - Dropout (typical): 0.27V @ 150mA
• Number Of Regulators: 1
• Current - Output: 150mA (Min)
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-5, SC-74A, SOT-25
• Number Of Outputs: 1
• Polarity: Positive
• Input Voltage Max: 6 V
• Output Voltage: 3 V
• Output Type: Fixed
• Dropout Voltage (max): 400 mV
• Output Current: 150 mA
• Line Regulation: 0.05 %
• Load Regulation: 0.5 %
• Voltage Regulation Accuracy: 0.5 %
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Limit (min): -
• Lead Free Status / Rohs Status: Details
• Other names: TC11863.0VCT713

TC1054/TC1055/TC1186
3.0
The descriptions of the pins are listed in
TABLE 3-1:
3.1
Connect unregulated input supply to the V
there is a large distance between the input supply and
the LDO regulator, some input capacitance is
necessary for proper operation. A 1 µF capacitor
connected from V
most applications.
3.2
Connect the unregulated input supply ground return to
GND. Also connect the negative side of the 1 µF typical
input decoupling capacitor close to GND and the
negative side of the output capacitor C
DS21350D-page 8
Pin No.
1
2
3
4
5
PIN DESCRIPTIONS
Unregulated Supply Input (V
Ground Terminal (GND)
PIN FUNCTION TABLE
IN
Symbol
ERROR
SHDN
V
to ground is recommended for
GND
V
OUT
IN
Unregulated supply input
Ground terminal
Shutdown control input
Out-of-Regulation Flag
(Open-drain output)
Regulated voltage output
OUT
Table
to GND.
IN
IN
3-1.
pin. If
)
3.3
The regulator is fully enabled when a logic-high is
applied to SHDN. The regulator enters shutdown when
a logic-low is applied to SHDN. During shutdown,
output voltage falls to zero, ERROR is open-circuited
and supply current is reduced to 0.5 µA (max).
3.4
ERROR goes low when V
approximately -5%.
3.5
Connect the output load to V
connect the positive side of the LDO output capacitor
as close as possible to the V
Description
Shutdown Control Input (SHDN)
Out Of Regulation Flag (ERROR)
Regulated Voltage Output (V
© 2007 Microchip Technology Inc.
OUT
OUT
OUT
is out-of-tolerance by
pin.
of the LDO. Also
OUT
)