TC1017-2.8VLTTR Microchip Technology, TC1017-2.8VLTTR Datasheet
![IC REG LDO 2.8V 150MA SD SC70-5](/photos/6/65/66533/mfg_sc-70_sml.jpg)
TC1017-2.8VLTTR
Specifications of TC1017-2.8VLTTR
Available stocks
Related parts for TC1017-2.8VLTTR
TC1017-2.8VLTTR Summary of contents
Page 1
... This can be as much as 60 times less than the quiescent operating current consumed by bipolar LDOs. The TC1017 is designed to be stable, over the entire input voltage and output current range, with low-value (1 µF) ceramic or tantalum capacitors. This helps to reduce board space and save cost. Additional inte- ...
Page 2
... TC1017 1.0 ELECTRICAL CHARACTERISTICS Absolute Maximum Ratings † Input Voltage ....................................................................6.5V Power Dissipation ......................... Internally Limited (Note 7) Maximum Voltage On Any Pin ..................V † Notice: Stresses above those listed under "Maximum Ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operation listings of this specification is not implied ...
Page 3
... Units T -40 — +125 ° -40 — +125 ° -65 — +150 °C A — 255 — °C/W JA — 450 — °C/W JA TC1017 , T = +25° Max Units Test Conditions — µ 5V mA µ µ 100 Hz OUT — 0V, Average OUT Current (Note 8) — V/W Notes 6, 7 — ...
Page 4
... TC1017 2.0 TYPICAL PERFORMANCE CHARACTERISTICS Note: The graphs and tables provided following this note are a statistical summary based on a limited number of samples and are provided for informational purposes only. The performance characteristics listed herein are not tested or guaranteed. In some graphs or tables, the data presented may be outside the specified operating range (e ...
Page 5
... FIGURE 2-11: Voltage. 2.869 V = 3.30V OUT 2.868 2.867 2.866 2.865 2.864 2.863 2.862 85 110 3.3 3.6 3.9 4.2 4.5 4.8 5.1 5.4 5.7 6.0 FIGURE 2-12: Voltage. TC1017 , T = +25° 3.30V OUT I = 150 mA OUT I = 100 mA OUT OUT - 110 Temperature (° ...
Page 6
... TC1017 Note: Unless otherwise noted 2.870 2.868 2.866 V = 6.0V 2.864 IN 2.862 2.860 V = 3.85V 2.858 IN 2.856 2.854 100 Load Current (mA) FIGURE 2-13: Output Voltage vs. Output Current. 2 2.85V T 1.8 OUT A 1.6 1.4 1.2 1.0 0.8 0.6 0.4 0.2 0.0 3.3 3.6 3.9 4.2 4 ...
Page 7
... OUT 100 1000 FIGURE 2-22 2.85V OUT V = 3.85V µ OUT FIGURE 2-23 2.85V OUT V = 3.85V µ FIGURE 2-24: TC1017 , T = +25° 3.85V µ µF Ceramic OUT V = 2.85V OUT = 0 120 mA Load Transient Response 3.85V µ 4.7 µF Ceramic OUT V = 2.85V OUT = 0 120 mA Load Transient Response ...
Page 8
... TC1017 Note: Unless otherwise noted 4.7 µF Ceramic OUT V = 2.85V OUT V = 3.85V to 4.85V IN FIGURE 2-25: Line Transient Response µF Ceramic OUT V = 4. 3.33V OUT FIGURE 2-26: Line Transient Response. DS21813D-page 100 µ 1.0 µF, SHDN > µ 120 mA LOAD FIGURE 2-27 µ ...
Page 9
... V should be less than or equal to 6V. IN Power dissipation may limit V order to maintain a junction temperature below 125°C. Refer to Section 5.0 “Thermal Considerations”, for determining junction temperature recommended that V ceramic capacitor. TC1017 Description ) OUT ) IN has to meet two conditions in order [(V + 2.5 The ...
Page 10
... TC1017 4.0 DETAILED DESCRIPTION The TC1017 is a precision, fixed-output, linear voltage regulator. The internal linear pass element is a P-channel MOSFET. As with all P-channel CMOS LDOs, there is a body drain diode with the cathode connected to V and the anode connected (Figure 4-1). ...
Page 11
... LDO. 4.2 Output Capacitor A minimum output capacitance of 1 µF for the TC1017 is required for stability. The Equivalent Series Resis- tance (ESR) requirements on the output capacitor are between 0 and 2 ohms. The output capacitor should be located as close to the LDO output as is practical ...
Page 12
... Power Dissipation: SC-70 The TC1017 is available in the SC-70 package. The thermal resistance for the SC-70 package is approximately 450°C/W when the copper area used in the PCB layout is similar to the JEDEC J51-7 high ther- mal conductivity standard or semi-G42-88 standard ...
Page 13
... Maximum Current vs. Ambient Temperature (SC-70 package). 5.3 Power Dissipation: SOT-23 The TC1017 is also available in a SOT-23 package for improved thermal performance. The thermal resistance for the SOT-23 package is approximately 255°C/W when the copper area used in the printed circuit board layout is similar to the JEDEC J51-7 low thermal conductivity standard or semi-G42-88 standard ...
Page 14
... TC1017 700 600 500 400 300 200 100 0 -40 - Ambient Temperature (°C) FIGURE 5-3: Power Dissipation vs. Ambient Temperature (SOT-23 Package). 160 140 120 OUT 100 -40 - Ambient Temperature (°C) FIGURE 5-4: Maximum Current vs. Ambient Temperature (SOT-23 Package). DS21813D-page 14 5.4 Layout Considerations The primary path for heat conduction out of the SC-70/ SOT-23 package is through the package leads ...
Page 15
... TC1017 – 1.8VLT CE TC1017 – 1.85VLT CQ TC1017 – 1.9VLT CB TC1017 – 2.5VLT CR TC1017 – 2.6VLT CF TC1017 – 2.7VLT CG TC1017 – 2.8VLT CH TC1017 – 2.85VLT CJ TC1017 – 2.9VLT CK TC1017 – 3.0VLT CL TC1017 – 3.2VLT CC TC1017 – 3.3VLT CM TC1017 – 4.0VLT CP TC1017 TC1017R Pinout Code ...
Page 16
... DS21813D-page 16 Part Number Code TC1017 – 1.8VCT DA TC1017 – 1.85VCT DK TC1017 – 2.6VCT DB TC1017 – 2.7VCT DC TC1017 – 2.8VCT DD TC1017 – 2.85VCT DE TC1017 – 2.9VCT DF TC1017 – 3.0VCT DG TC1017 – 3.3VCT DH TC1017 – 4.0VCT DJ Example: DANN © 2005 Microchip Technology Inc. ...
Page 17
... A1 .000 .004 E .071 .094 E1 .045 .053 D .071 .087 L .004 .012 Q1 .004 .016 c .004 .007 B .006 .012 TC1017 A MILLIMETERS* MIN NOM MAX 5 0.65 (BSC) 0.80 1.10 0.80 1.00 0.00 0.10 1.80 2.40 1.15 1.35 1.80 2.20 0.10 0.30 0.10 0.40 0.10 ...
Page 18
... TC1017 5-Lead Plastic Small Outline Transistor (OT) (SOT-23 Dimension Limits Number of Pins Pitch Outside lead pitch (basic) Overall Height Molded Package Thickness Standoff § Overall Width Molded Package Width Overall Length Foot Length Foot Angle Lead Thickness Lead Width Mold Draft Angle Top ...
Page 19
... To order or obtain information, e.g., on pricing or delivery, refer to the factory or the listed sales office PART NO. X.XX X Device Voltage Temperature Options Range Device: TC1017: 150 mA Tiny CMOS LDO with Shutdown TC1017R:150 mA Tiny CMOS LDO with Shutdown (SC-70 only) Voltage Options:* 1.8V (Standard) 1.85V 2.5V SC-70 only 2.6V 2 ...
Page 20
... TC1017 NOTES: DS21813D-page 20 © 2005 Microchip Technology Inc. ...
Page 21
... PowerCal, PowerInfo, PowerMate, PowerTool, rfLAB, rfPICDEM, Select Mode, Smart Serial, SmartTel, Total Endurance and WiperLock are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies. ...
Page 22
... Fax: 65-6334-8850 Taiwan - Kaohsiung Tel: 886-7-536-4818 Fax: 886-7-536-4803 Taiwan - Taipei Tel: 886-2-2500-6610 Fax: 886-2-2508-0102 Taiwan - Hsinchu Tel: 886-3-572-9526 Fax: 886-3-572-6459 © 2005 Microchip Technology Inc. EUROPE Austria - Weis Tel: 43-7242-2244-399 Fax: 43-7242-2244-393 Denmark - Ballerup Tel: 45-4450-2828 Fax: 45-4485-2829 France - Massy Tel: 33-1-69-53-63-20 ...