LT1763CS8#TRPBF Linear Technology, LT1763CS8#TRPBF Datasheet - Page 19

• Manufacturer Part Number: LT1763CS8#TRPBF
• Description: IC LDO REG LOW NOISE ADJ 8-SOIC
• Manufacturer: Linear Technology

Specifications of LT1763CS8#TRPBF

• Regulator Topology: Positive Adjustable
• Voltage - Output: 1.22 ~ 20 V
• Voltage - Input: 1.8 ~ 20 V
• Voltage - Dropout (typical): 0.3V @ 500mA
• Number Of Regulators: 1
• Current - Output: 500mA
• Current - Limit (min): 520mA
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Voltage Regulator Type: Linear
• Topology: LDO
• Regulator Output Type: Adjustable
• Polarity Type: Positive
• Number Of Outputs: Single
• Input Voltage (min): 1.8V
• Input Voltage (max): 20V
• Output Voltage: 1.22 to 20V
• Package Type: SOIC N
• Output Current: 500mA
• Load Regulation: 6mV
• Line Regulation: 5mV
• Operating Temp Range: -40C to 125C
• Operating Temperature Classification: Automotive
• Dropout Voltage@current (max): 0.19@10mA/0.22@50mA
• Dropout Voltage@current (typ): 0.13@10mA/0.17@50mA
• Pin Count: 8
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

APPLICATIONS INFORMATION
The top resistor of the resistor divider must be chosen to
limit the current into the ADJ pin to less than 5mA when
the ADJ pin is at 7V. The 13V difference between output
and ADJ pin divided by the 5mA maximum current into the
ADJ pin yields a minimum top resistor value of 2.6k.
In circuits where a backup battery is required, several
different input/output conditions can occur. The output
voltage may be held up while the input is either pulled
to ground, pulled to some intermediate voltage or is left
open-circuit. Current fl ow back into the output will follow
the curve shown in Figure 7.
100
90
80
70
60
50
40
30
20
10
0
0
Figure 7. Reverse Output Current
T
V
CURRENT FLOWS
INTO OUTPUT PIN
V
J
IN
OUT
LT1763-3
LT1763-2.5
= 25°C
1
= 0V
LT1763-1.8
= V
2
ADJ
OUTPUT VOLTAGE (V)
3
(LT1763)
LT1763
4
5
When the IN pin of the LT1763-X is forced below the OUT
pin, or the OUT pin is pulled above the IN pin, input cur-
rent will typically drop to less than 2μA. This can happen
if the input of the device is connected to a discharged
(low voltage) battery and the output is held up by either
a backup battery or a second regulator circuit. The state
of the SHDN pin will have no effect on the reverse output
current when the output is pulled above the input.
LT1763-3.3
6
7
LT1763-1.5
LT1763-5
8
9
1763 F07
10
LT1763 Series
19
1763fg