E3X-NH11 Omron, E3X-NH11 Datasheet - Page 14

• Manufacturer Part Number: E3X-NH11
• Description: SENSOR PHOTO AMP FIBEROPTIC NPN
• Manufacturer: Omron
• Type: High Precision Fiber Optic Amplifierr
• Series: E3X-NHr

Specifications of E3X-NH11

• Output Type: NPN
• Amplifier Type: General Purpose
• Voltage - Supply: 12 V ~ 24 V
• Current - Supply: 75mA
• Mounting Type: DIN Rail
• Features: Three mode for optimal sensing
• Light Source: Red LED
• Connection: Pre-leaded
• Output Configuration: NPN
• Sensor Output: NPN
• Switch Terminals: Cable
• Supply Voltage Min: 12V
• Peak Reflow Compatible (260 C): No
• Sensor Input: Fiber Optic
• Supply Voltage Max: 24V
• Leaded Process Compatible: No
• Rohs Compliant: No
• Fiber Optic Sensor Type: General Purpose
• Lead Free Status / RoHS Status: Contains lead / RoHS compliant by exemption
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant, Contains lead / RoHS compliant by exemption
• Other names: E3XNH11; Z1110

J ATTACHMENT UNITS
Applications
E39-F10 Fiber Connector
Use the following procedure (refer to the figure) to connect fibers
via the Fiber Connector.
Each Fiber Unit should be as close as possible before they are
connected.
Sensing distance will be reduced by approximately 25% when
fibers are connected.
Only fibers with a 2.2-mm dia. can be connected. (Refer to page
NO TAG for applicable Fiber Units.)
Protective Spiral Tube
Insert a fiber to the Protective Spiral Tube from the head
connector side (threaded) of the tube.
Push the fiber into the Protective Spiral Tube. The tube should be
straight so that the fiber is not twisted when inserted. Then turn
the end cap of the spiral tube.
Secure the Protective Spiral Tube on a suitable place with the
attached nut.
E3X-NH
Retention unit
Protective spiral
tube
Protective spiral
tube
Mounting panel
Protective spiral
tube
Splice
Fiber Unit
Fiber Unit
Toothed washer
Retention unit
Hexagon clamping nut
Fiber Unit
Fiber Unit
Use the attached saddle to secure the end cap of the Protective
Spiral Tube. To secure the Protective Spiral Tube at a position
other than the end cap, apply tape to the tube so that the portion
becomes thicker in diameter.
J AMPLIFIER UNITS
Mounting
1. Mount the front part (see #1) to the mounting bracket (attach-
2. Press the back part (see #2) onto the mounting bracket or
Note:
Removal
You can remove the Amplifier in one easy step:
1. Press the Amplifier Unit in direction (A) and lift the fiber inser-
(B)
ment) or on a DIN rail.
onto the DIN rail.
tion part in direction (B) as shown here
DO NOT mount the back part on the mounting bracket or
the DIN rail first and then mount the front part on the mount-
ing bracket on the DIN rail. This could decrease the mount-
ing strength of the Amplifier Unit.
(A)
(1)
DIN Rail
DIN Rail
(2)
End cap
Saddle
Tube
E3X-NH
15