GLK240128-25-FGW-E Matrix Orbital, GLK240128-25-FGW-E Datasheet - Page 23
![no-image](/images/no-image-200.jpg)
GLK240128-25-FGW-E
Manufacturer Part Number
GLK240128-25-FGW-E
Description
LCD GRAPHIC DISPL 240X128 WH BLU
Manufacturer
Matrix Orbital
Series
GLK240128-25r
Datasheet
1.GLK240128-25-FGW-V.pdf
(54 pages)
Specifications of GLK240128-25-FGW-E
Display Type
LCD - Monochrome
Display Mode
Reflective
Viewing Area
114.00mm L x 64.00mm W
Dot Pixels
240 x 128
Interface
I²C, RS232, TTL
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Backlight
-
Dot Size
-
Dot Pitch
-
Lead Free Status / Rohs Status
Details
Other names
GLK240128-25 -GW-E
GLK240128-25 -GW-E
GLK240128-25-GW-E
GLK240128-25-GW-E
GLK240128-25 -GW-E
GLK240128-25-GW-E
GLK240128-25-GW-E
When communication of either text or commands is interrupted, try the steps below.
*Note:
Should the settings of your display become altered in a way that dramatically impacts usability, the
default settings can be temporarily restored. To override the display, please follow the steps below.
1. Disconnect power from your display.
2. Place a jumper on the two manual override pins, for the GLK model these are the middle two
3. Reconnect power to your unit, and wait for the start screen before removing the jumper. Please
4. Settings will be
**Note:
17
5.3 Communication
5.4 Manual Override
•
•
•
•
•
•
•
•
keypad pins, for the GLT these are the two pins next to the keypad header.
note the jumper will adversely affect GLT performance if left in place during use.
table. At this point any important settings, such as contrast, backlight, or baud rate, should not only
be set but saved so they remain when the override is removed.
I²C communication will always require pull up resistors on SCL and SDA of one to ten kilohms.
The display module will revert back to the old settings once turned off, unless desired settings are saved.
First, check the communication cable for continuity. If you don't have an ohm meter, try using a
different communication cable. If you are using a PC try using a different Com Port.
Next, please ensure that the display module is set to communicate on the protocol that you are
using, by checking the Protocol Select Jumpers.
In serial protocol, ensure that the host system and display module are both communicating on
the same baud rate. The default baud rate for the display module is 19200 bps.
Match Rx from the GLK240128-25/GLT240128 to the transmitting pin from your host and the Tx
pin to the receiving pin.
If you are communicating to the display via
correct address. The default slave address for the display module is 80.
In I
Unlock the display. See the Set and Save Data Lock command for more info.
Finally, you may reset the display to its default settings using the Manual Override procedure.
2
C mode, connect Rx to the clock line of your controller and Tx to the data output.
temporarily**
overridden to the defaults listed in the Manual Override Settings
Table 15: Manual Override Settings
I
Parameter
Baud Rate
2
Backlight
Contrast
C Address
I²C*
19200
Value
please ensure that the data is being sent to the
255
128
80