AT86RF211-DK433107 Atmel, AT86RF211-DK433107 Datasheet - Page 18

• Manufacturer Part Number: AT86RF211-DK433107
• Description: KIT DEV FOR AT86RF211/433MHZ
• Manufacturer: Atmel
• Series: Smart RFr
• Type: Transceiverr

Specifications of AT86RF211-DK433107

• Mfg Application Notes: SmartRF Series Application Note
• Contents: 433MHz Frequency, 2 AVR Boards, Embedded Demos, In-System Programming possibility
• For Use With/related Products: AT86RF211 @ 433MHz
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: AT86RF211DK433107

5307C–WIRE–04/04
Using this Kit for (RF) Evaluation
4.2
4.2.1
4-4
Software
Description
SETUP
(Programming
Menu)
Note:
This evaluation software comprises two main screens:
The main menu is called the demo_ AT86RF211(TRX01) menu, where you are able to:
1. When the software is run, the SETUP menu appears. It provides quick access to
You can modify the default or loaded configuration according to your application:
Note:
SETUP screen: you can “manually” describe the AT86RF211 configuration wanted or
load a pre-registered set-up by pressing LOAD. The main menu is called
Setup_AT86RF211(TRX01). You may also enter the PRE-SETUP menu for less
frequently performed actions.
DEMO screen: open the DEMO screen by clicking on EXECUTE from the SETUP
window. The configuration is sent to the AT96RF211, and a link is established with the
transceiver. It also gives you access to the contents of the registers.
IF Frequency: 10.7 MHz for cost reduction (low cost filter, requiring a 10.245 MHz
crystal), or 21.4 MHz for better image rejection (more expensive filter, requiring a
20.945 MHz crystal).
– RESET (AT86RF211 hardware reset)
– DEBUG (direct link with all AT86RF211 registers)
– View registers’ contents (VIEW CTRL & STAT REG, VIEW FREQ…)
– Etc...
the configuration of parameters that are most frequently changed. Other param-
eters are changed in the PRE-SETUP. Click on PRE-SETUP at the bottom of the
SETUP window to change menu windows.
To close the program properly, ALWAYS use the Exit button (not the “X” at the
upper right hand corner of the window).
The IF filter and the crystal have to be chosen accordingly.
AT86RF211 Development Kit User Guide