XBIB-R Digi International/Maxstream, XBIB-R Datasheet - Page 46

• Manufacturer Part Number: XBIB-R
• Description: BOARD RS232 ZIGBEE MOD PRO
• Manufacturer: Digi International/Maxstream

Specifications of XBIB-R

• Design Resources: XBIB-R Schematic
• Accessory Type: Interface Board
• For Use With/related Products: XBee and XBee Pro Radios
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

XBee/XBee‐PRO™ OEM RF Modules ‐ 802.15.4 ‐ v1.xAx [2007.05.031]
MM (MAC Mode) Command
MY (16-bit Source Address) Command
NB (Parity) Command
<Networking {Addressing}> The MM command is
used to set and read the MAC Mode value. The
MM command disables/enables the use of a Max-
Stream header contained in the 802.15.4 RF
packet. By default (MM = 0), MaxStream Mode is
enabled and the module adds an extra header to
the data portion of the 802.15.4 packet. This
enables the following features:
The MM command allows users to turn off the use
of the extra header. Modes 1 and 2 are strict
802.15.4 modes. If the MaxStream header is dis-
abled, ND and DN parameters are also disabled.
Note: When MM > 0, application and CCA failure
retries are not supported.
<Networking {Addressing}> The MY command is
used to set and read the 16-bit source address of
the RF module.
By setting MY to 0xFFFF, the reception of RF pack-
ets having a 16-bit address is disabled. The 64-bit
address is the module’s serial number and is
always enabled.
<Serial Interfacing> The NB command is used to
select/read the parity settings of the RF module
for UART communications.
© 2007 MaxStream, Inc.
• ND and DN command support
• Duplicate packet detection when using ACKs
AT Command: ATMY
Parameter Range: 0 - 0xFFFF
Default Parameter Value: 0
Related Commands: DH (Destination Address
High), DL (Destination Address Low), CH
(Channel), ID (PAN ID)
AT Command: ATNB
Parameter Range: 0 - 4
Default Parameter Value: 0
Number of bytes returned: 1
AT Command: ATMM
Parameter Range:0 - 2
Default Parameter Value:0
Related Commands: ND (Node Discover), DN
(Destination Node)
Minimum Firmware Version Required: v1.x80
Parameter
Parameter
Chapter 3 ‐ RF Module Configuration
0
1
2
3
4
0
1
2
(802.15.4 + MaxStream
802.15.4 (with ACKs)
8-bit (no parity or
802.15.4 (no ACKs)
7-bit (any parity)
MaxStream Mode
Configuration
Configuration
8-bit space
8-bit mark
8-bit even
8-bit odd
header)
46