UPC3225TB-A CEL, UPC3225TB-A Datasheet - Page 15

• Manufacturer Part Number: UPC3225TB-A
• Description: IC MMIC AMP 6-SUPER MINIMOLD
• Manufacturer: CEL
• Type: RF IC'sr

Specifications of UPC3225TB-A

• Current - Supply: 24.5mA
• Frequency: 2.8GHz ~ 3.2GHz
• Gain: 32.5dB
• Noise Figure: 3.7dB
• Package / Case: SC-70-6, SC-88, SOT-363
• Rf Type: DBS
• Voltage - Supply: 4.5V ~ 5.5V
• Operating Frequency: 2.8 GHz
• P1db: 7 dBm
• Operating Supply Voltage: 4.5 V to 5.5 V
• Supply Current: 24.5 mA
• Maximum Power Dissipation: 270 mW
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Test Frequency: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

NOTES ON CORRECT USE
(1) Observe precautions for handling because of electro-static sensitive devices.
(2) Form a ground pattern as widely as possible to minimize ground impedance (to prevent undesired oscillation).
(3) The bypass capacitor should be attached to the V
(4) The inductor (L) must be attached between V
(5) The DC cut capacitor must be attached to input and output pin.
RECOMMENDED SOLDERING CONDITIONS
methods and conditions other than those recommended below, contact your nearby sales office.
Infrared Reflow
Wave Soldering
Partial Heating
Caution Do not use different soldering methods together (except for partial heating).
All the ground pins must be connected together with wide ground pattern to decrease impedance difference.
accordance with desired frequency.
This product should be soldered and mounted under the following recommended conditions.
Soldering Method
Peak temperature (package surface temperature)
Time at peak temperature
Time at temperature of 220°C or higher
Preheating time at 120 to 180°C
Maximum number of reflow processes
Maximum chlorine content of rosin flux (% mass)
Peak temperature (molten solder temperature)
Time at peak temperature
Preheating temperature (package surface temperature) : 120°C or below
Maximum number of flow processes
Maximum chlorine content of rosin flux (% mass)
Peak temperature (terminal temperature)
Soldering time (per side of device)
Maximum chlorine content of rosin flux (% mass)
Data Sheet PU10500EJ01V0DS
CC
Soldering Conditions
and output pins. The inductance value should be determined in
CC
pin.
: 260°C or below
: 120±30 seconds
: 260°C or below
: 1 time
: 350°C or below
: 3 seconds or less
: 10 seconds or less
: 60 seconds or less
: 3 times
: 0.2%(Wt.) or below
: 10 seconds or less
: 0.2%(Wt.) or below
: 0.2%(Wt.) or below
Condition Symbol
UPC3225TB
WS260
HS350
For soldering
IR260
15