NBB-402-T1 RFMD, NBB-402-T1 Datasheet - Page 3

• Manufacturer Part Number: NBB-402-T1
• Description: IC AMP MMIC GAAS 8GHZ 9-MPGA
• Manufacturer: RFMD

Specifications of NBB-402-T1

• Current - Supply: 35mA ~ 55mA
• Frequency: 0Hz ~ 8GHz
• Gain: 15.8dB
• Noise Figure: 4.3dB @ 3GHz
• P1db: 15.8dBm
• Package / Case: 9-MPGA
• Rf Type: LMDS, VSAT, WLAN, UNII, DWDM, PTP PMP
• Test Frequency: 2GHz
• Voltage - Supply: 3.6V ~ 4.2V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: NBB-402TR13; NBB-402TR13

Rev A6 060124
Pin
1
2
3
4
5
6
7
8
9
Function
RF OUT
RF IN
GND
GND
GND
GND
GND
GND
GND
Description
Ground connection. For best performance, keep traces physically short
and connect immediately to ground plane.
Same as pin 1.
Same as pin 1.
RF input pin. This pin is NOT internally DC blocked. A DC blocking
capacitor, suitable for the frequency of operation, should be used in
most applications. DC coupling of the input is not allowed, because this
will override the internal feedback loop and cause temperature instabil-
ity.
Same as pin 1.
Same as pin 1.
Same as pin 1.
RF output and bias pin. Biasing is accomplished with an external series
resistor and choke inductor to V
DC current into this pin to a desired level. The resistor value is deter-
mined by the following equation:
Care should also be taken in the resistor selection to ensure that the
current into the part never exceeds maximum datasheet operating cur-
rent over the planned operating temperature. This means that a resistor
between the supply and this pin is always required, even if a supply
near 5.0V is available, to provide DC feedback to prevent thermal run-
away. Alternatively, a constant current supply circuit may be imple-
mented. Because DC is present on this pin, a DC blocking capacitor,
suitable for the frequency of operation, should be used in most applica-
tions. The supply side of the bias network should also be well
bypassed.
Same as pin 1.
R
=
(
------------------------------------------ -
V
CC
CC
. The resistor is selected to set the
–
I
V
CC
DEVICE
)
RF IN
Interface Schematic
NBB-402
RF OUT
4-43