A24-HASM-450 Digi International/Maxstream, A24-HASM-450 Datasheet - Page 21

no-image

A24-HASM-450

Manufacturer Part Number
A24-HASM-450
Description
ANT 2.4GHZ DIPOLE HALF-WAVE
Manufacturer
Digi International/Maxstream
Series
XPressr
Datasheets

Specifications of A24-HASM-450

Antenna Type
Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
Number Of Bands
1
Frequency
2.4GHz
Vswr
2
Gain
2.1dBi
Termination
RP-SMA
Mounting Type
Connector
Height (max)
4.35" (110.5mm)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
70000340
Q2724499B
XBee/XBee‐PRO ZigBee OEM RF Modules v1.x1x  [2007.06.01]
4.1.4. Network Reset
address of the end device can be read using the MY (16-bit Source Address) command. If API is
enabled (AP parameter > 0), the API modem status “Joined” is sent out the UART. The AI
(Association Indication) command can be used at any point during the end device join routine to
know the status of the startup operation.
Once a coordinator has started, or a router or end device has joined the network, the device will
continue operating on that channel and PAN ID unless one of the following occurs:
operating channel is not included in the new SC parameter
If any of the above occurs on a coordinator, the coordinator will attempt to restart on a channel
and PAN ID based on the new saved ID and SC commands. On a router or end device, the above
conditions will cause the device to leave the network (if previously joined) and attempt to join a
new PAN using the saved ID and SC parameters.
© 2007 Digi International, Inc.
1. The ID parameter changes, and is saved using the WR command
2. The SC parameter changes and is saved using the WR command, such that the current
3. The NR command is issued with either 0 or 1 as a parameter
Chapter 4 ‐ RF Module Configuration
     21

Related parts for A24-HASM-450