SDK-AC4868-250M Laird Technologies, SDK-AC4868-250M Datasheet - Page 31
![KIT DESIGN FOR AC4868-250M](/photos/14/10/141013/sdk-ac4868-250m_sml.jpg)
SDK-AC4868-250M
Manufacturer Part Number
SDK-AC4868-250M
Description
KIT DESIGN FOR AC4868-250M
Manufacturer
Laird Technologies
Series
AeroCommr
Type
Transceiverr
Specifications of SDK-AC4868-250M
Frequency
868MHz
Board Size
49 mm x 42 mm x 5 mm
Output Power
250 mW
Antenna
MMCX
Silicon Manufacturer
Laird Technologies
Kit Application Type
Communication & Networking
Application Sub Type
RF Module
Kit Contents
2x RF Module, 2x Adapter Board, CD, 2x AC Power Adapters, 2x
Rohs Compliant
Yes
For Use With/related Products
AC4868-250M
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Developer Kit User’s Manual
If these troubleshooting tips do not resolve the problem, please contact the support engineer referenced
on the cover sheet in the SDK binder. Please use our toll free support number at (800) 492-2320.
Technical support hours are Monday through Friday, 8:00 AM to 5:00 PM Central Standard Time.
10/2/05
Packets can be sent between both radios
using Aerocomm OEM.exe but cannot be
sent from software or hardware not
supplied by Aerocomm.
A Framing or Data Timeout error occurs
while running a Range Test.
5. Make sure one radio is a Server and one is a Client
6. Check radio addressing.
7. Make sure that radios are separated by at least ten
8. Make sure the In Range LED is lit on both
1. Use the Hardware section of this manual to
2. Make sure the baud rate of the radios matches that
3. Make sure the Status 1 LED is not turned on. If so,
1. Verify that the baud rate on the PC Settings page
2. Verify that both radios are powered on and that the
3. Verify that the In Range LED is lit on both radios.
(excluding AC4790).
feet.
transceivers.
determine if a null-modem adapter is required for
interfacing to the hardware.
of the OEM Host hardware.
find out what is driving RTS Low (thus, turning on
the Status 1 LED) and either slide the Program
Mode/Normal Mode switch to Normal, or cause
RTS to go High.
matches that of the radio’s EEPROM.
Port settings are correct.
31