RZB-CC16C-ZDK Renesas Electronics America, RZB-CC16C-ZDK Datasheet - Page 16

• Manufacturer Part Number: RZB-CC16C-ZDK
• Description: KIT DEMO ZIGBEE 2.4GHZ
• Manufacturer: Renesas Electronics America
• Type: 802.15.4/Zigbeer

Specifications of RZB-CC16C-ZDK

• Frequency: 2.4GHz
• For Use With/related Products: M16C/28
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

7.0 RZB-CC16C-ZDK Board Specifications
7.1. Hardware Specifications
Table 7-1
Table 7-1: RZB-CC16C-ZDK Board Specifications
7.2. Power Supply Requirements
The RZB-CC16C-ZDK Board will draw about 35mA with no LEDs on. With the ICD powered from the
board, the current draw will be about 85mA.
The board has a 3.3V low dropout voltage regulator with an input voltage range from 3.4V to 16V.
7.3. Operating Environment
Table 7-2
board in a conductive bag inside the original factory packaging box.
Table 7-2: Operating Environment
RZB-CC16C-ZDK User’s Manual Rev 1.0
MCU
Clocks
Memory
(ICD)
Connectors
Jumpers
Switches
LEDs
LCD
Operating
Storage
Environmental Condition
Item
lists the specifications of the RZB-CC16C-ZDK Board.
lists the environmental conditions for using and storing the RZB-CC16C-ZDK board. Store the
M30280FAHP
[D1] (Red): User output (connected to P3_4)
Main Clock: crystal 10 MHz, PLL, or ring oscillator
Sub Clock: 32.768 kHz crystal
RAM: 8kB (8064 Bytes user available due to kernel)
High E/W Data Block: 2kB × 2 (4096 Bytes)
Flash ROM: 96kB (94kB user available due to kernel)
[J1-J4]: Four 2×10-pin measurement test points connected to the MCU
pins. Can also be used to connect your own expansion boards via 2×10
headers.
[J7]: In-Circuit Debug connector (UART1 for FoUSB-ICD)
[P1]: 9-Sub-D RS232 connected via RS232 transceiver to UART2
[JP1]: MCU Power for Icc Measurements
[JP2]: Power LED and RS232 Power connect
[S1]: pushbutton (connected to P10_4)
[S2]: pushbutton (connected to P10_5)
[S3]: pushbutton (connected to P10_6)
[S4]: pushbutton (connected to Reset)
[SW1]: Power source select switch. If set toward the ICD connector: power
provided by ICD. If set toward the power connector: power provided via
power connector.
[D2] (Yellow): User output (connected to P3_5)
[D3] (Green): User output (connected to P3_6)
[D4] (Red): Power On (if jumper JP2 shorted)
2-line × 8-character LCD with KS0066 controller IC
0 - 55°C
(No corrosive gas allowed)
-30 to 75°C
(No corrosive gas allowed)
Ambient Temperature
16/ 29
Specification
30 to 80% (non-condensing)
30 to 80% (non-condensing)
Ambient Humidity
Applications Engineering
August 2005