CN4490-1000-SP Laird Technologies, CN4490-1000-SP Datasheet - Page 26

• Manufacturer Part Number: CN4490-1000-SP
• Description: TXRX ETH BRIDGE 900MHZ 1W ANT&PS
• Manufacturer: Laird Technologies
• Series: AeroCommr

Specifications of CN4490-1000-SP

• Function: 2 Transceivers
• Modulation Or Protocol: FHSS, FSK
• Frequency: 902MHz ~ 928MHz
• Applications: General Purpose
• Interface: RJ-45
• Sensitivity: -99dBm
• Power - Output: 1000mW
• Data Rate - Maximum: 115.2kbps
• Features: 2 ConnexNet Transceivers in Ethernet Bridge Mode
• Voltage - Supply: 7 V ~ 18 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

E T H E R N E T B R I D G E C O N F I G U R A T I O N
E n a b l i n g E t h e r n e t B r i d g e f u n c t i o n
E N G I N E E R ’ S T I P
When Bridging is enabled
• You will not be able to configure the radio module once bridging is enabled.
• You will not be able to access the web interface to configure the Ethernet device.
• The only way to connect to the device to configure is via Telnet port 23.
• DHCP must be disabled. The device must be assigned a static IP address. Check with your
IT department before proceeding.
1
2
3
4
5
Install the Multitech Auto Discovery Manager software. Available online
http://aerocomm.com/software/Auto_Discovery_Mgr.zip
Connect your device to the network via a switch, router, hub, etc. so that it can be assigned a
DHCP IP address.
Open the Auto Discovery Manager & wait for your device to be discovered.
Double-click on the discovered device to bring up the Edit Attributes dialog.
Write down the value of the DHCP IP Address.
www.aerocomm.com
D E V I C E S E T U P
2 1