F2M03GXA-S01 Free2Move, F2M03GXA-S01 Datasheet - Page 36
![MOD BLUETOOTH V2.0+EDR EXT W/ANT](/photos/14/20/142006/f2m03gxa-s01_sml.jpg)
F2M03GXA-S01
Manufacturer Part Number
F2M03GXA-S01
Description
MOD BLUETOOTH V2.0+EDR EXT W/ANT
Manufacturer
Free2Move
Datasheet
1.F2M03GX-S01.pdf
(47 pages)
Specifications of F2M03GXA-S01
Frequency
2.4GHz
Data Rate - Maximum
3Mbps
Modulation Or Protocol
Bluetooth v2.0+EDR, Class 1, 2 & 3
Applications
Bluetooth v2.0
Power - Output
-8dBm ~ 18dBm
Sensitivity
-92dBm
Voltage - Supply
3.1 V ~ 3.6 V
Current - Receiving
38mA
Current - Transmitting
250mA
Data Interface
PCB, Surface Mount
Antenna Connector
On-Board, Chip
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Memory Size
-
Other names
647-1013-2
Rev: c
Extended range Bluetooth™ Module - F2M03GX /GXA
Datasheet
7.2
Layout guidelines
The module uses bottom pads for soldering optimized for an automatic solder line. It is also possible to
solder the module manually by using hot air soldering. For manual soldering solder pads may in some
situation be made slightly larger to allow easier heating process.
To achieve good RF performance it is recommended to place ground plane(s) beneath the module but not
under the antenna. The ground planes should be connected with vias surrounding the module. Except from
the ground plane it is preferable that there are as few components and other material as possible nearby
the antenna. Free air is the best surrounding for the antenna.
All GND pads must be connected directly to a flooded ground-plane. If more then one ground layer is used
then make a good connection between them using many via holes. +VCC and +V_PA should be connected
to the LDO using a wide trace.
Antenna
Vias
U.FL-connector
Vias
Ground layers
Ground layers
F2M03GX
F2M03GXA
© 2006 Free2move AB
Page 36(47)