ATZB-A24-UFL Atmel, ATZB-A24-UFL Datasheet - Page 10

• Manufacturer Part Number: ATZB-A24-UFL
• Description: KIT MOD 802.15.4/ZIGB 2.4GHZ W/U
• Manufacturer: Atmel

Specifications of ATZB-A24-UFL

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: Home/Building Automation, Industrial Control and Monitoring
• Power - Output: 20dBm
• Sensitivity: -104dBm
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Receiving: 23mA
• Current - Transmitting: 50mA
• Data Interface: PCB, Surface Mount
• Memory Size: 128kBytes Flash, 8kBytes RAM, 4kBytes EEPROM
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.1
3.1.1
3.1.2
ZigBit™ 2.4 GHz Amplified Wireless Modules
Electrical Characteristics
Absolute Maximum Ratings
Test Conditions
Table 3-1. Absolute Maximum Ratings
Notes:
,
Table 3-2. Test conditions (unless otherwise stated) F = 2.45 GHz, V
Note:
Voltage on any pin, except RESET with respect to Ground
DC Current per I/O Pin
DC Current DVCC and DGND pins
Input RF Level
Supply Voltage, V
Current Consumption: RX mode
Current Consumption: TX mode
Current Consumption: Power-save mode
1. Absolute Maximum Ratings are the values beyond which damage to the device may occur. Under no
2. Attention! ZigBit AMP is an ESD-sensitive device. Precaution should be taken when handling the
1. The parameters are measured under the following conditions:
circumstances must the absolute maximum ratings given in this table be violated. Stresses beyond
those listed under "Absolute Maximum Ratings" may cause permanent damage to the device.
This is a stress rating only. Functional operation of the device at these or other conditions, beyond those
indicated in the operational sections of this specification, is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
device in order to prevent permanent damage.
a) RMS, BitCloud Software is running at 4 MHz clock rate, DTR line management is turned off
b) All interfaces are set to the default state (see Pin Assignment Table)
c) Output TX power (when measuring consumption in TX mode) is +20dBm
d) JTAG is not connected
CC
Parameters
Parameters
(1)
(1)
(1)(2)
-0.5V
Min
CC
= 3V, T
3.0 to 3.6
Range
Specifications
< 6
23
50
amb
= 25°C
8228B–MCU Wireless–06/09
VCC + 0.5V
Section 3
300 mA
+5 dBm
40 mA
Max
Unit
mA
mA
µA
V
3-7