BGA/CSP-NK OKI METCAL, BGA/CSP-NK Datasheet - Page 11

• Manufacturer Part Number: BGA/CSP-NK
• Description: KIT NOZZLE BGA/CSP
• Manufacturer: OKI METCAL

Specifications of BGA/CSP-NK

• Tip - Type: Rework
• Tip - Size: Assorted Sizes
• Tip - Shape: Quad
• For Use With/related Products: BGA and CSP Rework systems
• Other names: BGACSPNK

14. Cool Air Fitting: This fitting connects to the large diameter hose with the blue ring
15. Vacuum Connection Fitting: Connects to the small diameter vacuum hose extending
16. Hot Air Fitting: This fitting connects to the unmarked large diameter hose extending
17. Reflow Head Electrical Connector: This receptacle accepts the electrical connector
18. Start Cycle Button: This button to starts the rework cycle. Pressing this button while
19. Bottom Display Up/Down Keys: Use these keys to increase or decrease any displayed
10. Mode/Zone keys: Selects between Place and Lift modes of machine operation.
11. Top Display Up / Down Keys: Use these keys to increase or decrease any displayed value in the
12. Type-K Thermocouple Input: When the switch (18) is in the “Thermocouple” position the bottom
13. Vacuum On / Off switch: Toggles the
14. Preheater Mode Selector: Allows
15. Time / Thermocouple Switch: Sets
16. Lock button: Provides lockout feature
BGA-3500 Series Manual 5/01
upper display during setting up of the profile (i.e. temperature). The keys also change system
parameters (i.e. °C to °F).
display will read the temperature measured by the K-Type thermocouple connected to this input.
vacuum in the Micro Oven head
assembly on and off.
manual activation of preheater.
Switch must be in the automatic
position for correct operation with the
software.
the bottom display of the BGA
module to read either the tempera-
ture of an external thermocouple or
time when running or programming
profiles.
(when you are not using the security
features of the software) to prevent
tampering with module profiles.
extending from the Reflow Head assembly.
from the Reflow Head assembly.
from the Reflow Head assembly.
from the Reflow Head Assembly.
running a profile will advance the profile into the next zone.
value in the lower display during setting up of the profile.
Figure 3
16
13
12
8
14
7
15
11
10
9
6
5
4
2
3
1
9