BF140D03BK1200 CH PRODUCTS, BF140D03BK1200 Datasheet - Page 3
![JOYSTICK BF SERIES CONTACTLESS](/photos/14/85/148524/bf140d03bk1200_sml.jpg)
BF140D03BK1200
Manufacturer Part Number
BF140D03BK1200
Description
JOYSTICK BF SERIES CONTACTLESS
Manufacturer
CH PRODUCTS
Series
BFr
Type
Joystick, Panel Mountr
Datasheet
1.BF240SD3GR2500.pdf
(8 pages)
Specifications of BF140D03BK1200
Output
Analog (Hall Effect)
Switch Function
1 Axis
Actuator Type
Paddle
Termination Style
Connector
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Contact Rating @ Voltage
-
Operating Force
-
Other names
679-2370
BF SERIES PADDLE - CONTACTLESS JOYSTICK & SWITCH
CONFIGURATIONS & OUTPUTS
OUTPUT OPTIONS
The BF Series Paddle is configured as two “electrical” controls in one mechanical package. The Paddle operates from 5V and
provides two proportional outputs. The second output is accurate to the first within +/-2% of the power supply. The power supply
for the secondary output is also completely independent. Customers may choose their preference of voltage outputs (gains).
The secondary output can be of the same or inverse polarity to the primary wiper. For example, with a secondary inverse output,
the first and second outputs can be summed and compared to zero to verify that the joystick is operating correctly. Paddles having
two identical outputs of the same polarity may be used to drive two identical dual redundant circuits.
There are also two Hall Effect switches that trigger at pre-determined lever positions.
The BF Series Paddle may be specified with a variety of PWM output options. For more details on available PWM options please
refer to Apem.
ADDITIONAL OUTPUT INFORMATION
SELECTABLE SWITCHING POINTS
The Paddle incorporates two Hall Effect switches. The angle of the lever at the switch trigger point can be selected when ordering.
If no switches are specified then the output on pins 2 and 7 will be unused.
The outputs are configured as ‘open drain’ type with a 1K5 pull up resistor to 5V.
GAIN OPTIONS
The voltage output on the wiper, at full scale deflection is determined by the gain. The gain is expressed as a percentage of the
voltage supplied. Therefore (assuming a 5V supply) a Paddle specified with +/- 25% gain would yield 1.25V at South, 2.5V at
centre and 3.75V at North. A range of gain options are available as standard. All controls are supplied pre-set and no further
calibration is needed throughout the lifetime of operation.
OUTPUT IMPEDANCE
The voltage outputs at centre and at each end of travel are specified across an infinite load, with no current flowing. The output
impedance specified in the electrical specification should be taken into account when designing a system. Load resistance of less
than 10K Ohms is not recommended.
www.apem.com
3
Note: The company reserves the right to change specifications without notice.