A22L-GW-6D-01M Omron, A22L-GW-6D-01M Datasheet - Page 35
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
A22L-GW-6D-01M
Manufacturer Part Number
A22L-GW-6D-01M
Description
SWITCH PB ILLUM RND MOM SPST WHT
Manufacturer
Omron
Series
A22r
Type
Illuminatedr
Datasheet
1.A22-FA.pdf
(36 pages)
Specifications of A22L-GW-6D-01M
Circuit
SPST-NC
Switch Function
On-Mom
Contact Rating @ Voltage
10A @ 110VAC
Actuator Type
Round, Clear Full Guard
Illumination Type, Color
LED, White
Illumination Voltage (nominal)
6 VDC
Mounting Type
Panel Mount
Termination Style
Screw Terminal
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
A22LGW6D01M
• Do not place PCBs that have had flux applied or have been
• When performing soldering with a dip soldering bath, ensure that
• Flux is especially likely to rise up at the edges of the PCB. If the
soldered on top of each other. Otherwise, the flux on the PCBs
solder surface may stain the upper part of the Switch or even
permeate the inside of the Switch and cause contact failure.
Be sure to insert a special PCB stocker.
the flux does not reach a higher level than the PCB.
Switch is mounted near the edge of the PCB, create a gap between
the edge by using a split PCB, and insert the PCB in the soldering
bath so that the edge that is farthest from the Switch enters the bath
first.
Create distance
http://www.ia.omron.com/
Flux
Split PCB
Flux is more likely
to rise at the edges.
Do not place PCBs
with solder or flux on
top of each other.
Create distance
Insert in soldering
bath from this
edge.
Technical Guide for Pushbutton Switches
Storage
• When the Switch is left unused or stored for long periods, the
• If the Switch is stored in a location where it will be exposed to direct
ambient conditions can have a great effect on the condition of the
Switch. In certain environments, leaving the Switch exposed may
result in deterioration (i.e., oxidation, or the creation of an oxide
film) of the contacts and terminals, causing the contact resistance
to increase, and making it difficult to solder the lead wires.
Therefore, store in a well-ventilated room, inside, for example, a
non-hygroscopic case, in a location where no corrosive gases are
present.
light, colored resin in the colored plate may fade. Therefore, do not
store the Switch in locations where it will be exposed to direct light.
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
C-6