TSE397C-100G MG Chemicals, TSE397C-100G Datasheet - Page 3

• Manufacturer Part Number: TSE397C-100G
• Description: ADHESIVE SEAL SIL NON-CORROSIVE
• Manufacturer: MG Chemicals
• Series: RTVr
• Type: Potting Compound, 1 Partr

Specifications of TSE397C-100G

• Features: Self Leveling
• Application: Excellent for thin section potting, filling small surface voids, self leveling and protective coatings
• Chemical Component: Silicone
• Color: Translucent
• Dielectric Strength: 20 KV⁄mm
• Dispensing Method: Tube
• Elongation: 300%
• Hardness: 20 (Shore A)
• Primary Type: Adhesive
• Special Features: Clear Semi Flowable
• Specific Gravity: 1.04
• Temperature Range: -55 to +200 °C
• Temperature, Rating: -55 to +200 °C
• Tensile Strength: 1.1 MPa
• Thermal Conductivity: 0.21 W⁄m.°K
• Time, Cure: 3 Days
• Time, Setting: 10 min.
• Viscosity: 50000 cps
• Volume Resistivity: 2.0 x 10^15 Ohm.cm
• Weight: 3.5 Oz.
• Product: Silicones
• Size: 3.5 oz
• For Use With/related Products: Non Corrosive
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

{ error: graphic file not found:
E:\TC_MSDS_5028\webapps\ehswww\WEB-
INF\bin\graphics\vkoJP01.bmp }
5. FIRE-FIGHTING MEASURES
FLASH POINT:
FLAMMABLE LIMITS IN AIR - LOWER (%):
FLAMMABLE LIMITS IN AIR - UPPER (%):
SENSITIVITY TO MECHANICAL IMPACT:
SENSITIVITY TO STATIC DISCHARGE
EXTINGUISHING MEDIA
SPECIAL FIRE FIGHTING PROCEDURES
6. ACCIDENTAL RELEASE MEASURES
ACTION TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED
7. HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS
RESPIRATORY PROTECTION
TSE 397 C - cartg (310ml - 322g)
SILICONE RUBBER SEALANT
Sensitivity to static discharge is not expected.
All standard extinguishing agents are suitable.
Firefighters must wear NIOSH/MSHA approved positive pressure self-contained breathing
apparatus with full face mask and full protective clothing.
Wipe, scrape or soak up in an inert material and put in a container for disposal. Wash walking
surfaces with detergent and water to reduce slipping hazard. Wear proper protective equipment as
specified in the protective equipment section.
Keep container closed when not in use. Avoid contact with skin and eyes. Remove contact lenses
before using sealant. Do not handle lenses until all sealant has been cleaned from the fingertips, nails
and cuticles. Residual sealant may remain on fingers for several days and transfer to lenses and
cause severe eye irritation. Do not inhale vapors. Keep away from children.
Eyewash stations; Showers; Exhaust ventilation
If exposure limits may be exceeded or respiratory irritation is experienced, NIOSH/MSHA approved
respiratory protection should be worn. A NIOSH/MSHA approved respirator with an organic vapor
cartridge is generally acceptable. Supplied airrespirators may be required for high vapor
Page 3/7
> 198 °C; 388 °F
Not applicable
Not applicable
No
Material Safety Data Sheet
Version: 1.2
10/04/2007