VNCLO-PSU-USA FTDI, VNCLO-PSU-USA Datasheet - Page 11

• Manufacturer Part Number: VNCLO-PSU-USA
• Description: Interface Modules & Development Tools Vinculo +9V/1A USA Power Supply Unit
• Manufacturer: FTDI

Specifications of VNCLO-PSU-USA

• Interface Type: USB, Serial, UART, FIFO, SPI
• Data Bus Width: Serial, 8 bit
• Operating Supply Voltage: 100 VAC to 240 VAC
• Product: Interface Development Tools
• For Use With/related Products: VNC2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.3 USB Slave Port : Pins and Signal Description
Connector CN3 is a USB mini-B, designed for connecting to USB hosts. This connector routes to the
VNC2-64Q USB port 1 and the firmware on the VNC2-64Q should be written to ensure it is in slave mode.
The port is USB 2.0 full speed compliant.
This port can also be used to provide power to the Vinco with 5V at 500mA max.
Table 3.3 – USB Slave Pin Out
3.4 USB Host Port : Pins and Signal Description
Connector CN2 is a USB type A connector designed for connecting to USB devices. This connector routes
to the VNC2-64Q USB port 2 and the firmware on the VNC2-64Q should be written to ensure it is in host
mode.
The port is USB 2.0 full speed compliant.
Table 3.4 – USB Slave Pin Out
Pin No.
Pin No.
J1-1
J1-2
J1-3
J1-4
J1-5
1
2
3
4
Copyright © 2010-2011 Future Technology Devices International Limited
5V (can be used to power
PCB or disabled with JP1)
5V supply to peripheral
device. Enabled by the
Not connected
VNC2-64Q
USB DM
USB DM
USB DP
USB DP
Signal
Signal
GND
GND
Vinco Development Module Datasheet Version 2.0
Document Reference No.: FT_000327
Clearance No.: FTDI#173
7