LPC-P2919 Olimex Ltd., LPC-P2919 Datasheet - Page 3
![MCU, MPU & DSP Development Tools DEV BRD FOR LPC2919 768KB FLASH 56KBSRAM](/photos/15/90/159060/lpc-p2919-1_sml.jpg)
LPC-P2919
Manufacturer Part Number
LPC-P2919
Description
MCU, MPU & DSP Development Tools DEV BRD FOR LPC2919 768KB FLASH 56KBSRAM
Manufacturer
Olimex Ltd.
Datasheet
1.LPC-P2919.pdf
(21 pages)
Specifications of LPC-P2919
Processor To Be Evaluated
LPC2919 ARM968E-S
Data Bus Width
16 bit, 32 bit
Interface Type
RS-232, CAN, SPI
Dimensions
140 mm x 89 mm
Operating Supply Voltage
9 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
ELECTROSTATIC WARNING:
BOARD USE REQUIREMENTS:
PROCESSOR FEATURES:
The LPC-P2919 board is shipped in protective anti-static packaging. The board must
not be subject to high electrostatic potentials. General practice for working with
static sensitive devices should be applied when working with this board.
Cables: The cable you will need depends on the programmer/debugger you use. If
you use ARM-USB-OCD, you will need RS232 cable and 1.8 meter USB A-B cable
and if you use ARM-USB-TINY, you will need 1.8 meter USB A-B cable.
Hardware: Programmer/Debugger – one of the Olimex ARM Programmers: ARM-
USB-OCD, ARM-USB-TINY.
Software: ARM C compiler and JTAG programmer, the possible options are:
LPC-P2919 board use ARM9 32-bit microcontroller LPC2919FBD144 from NXP
Semiconductors with these features:
–
–
–
–
–
–
–
–
–
–
–
ARM968E-S processor at 80 MHz maximum
Multi-layer AHB system bus at 80 MHz with three separate layers
On-chip memory:
Two-channel CAN controller supporting Full-CAN and extensive message
filtering.
Two LIN master controllers with full hardware support for LIN communication
Two 550 UARTs with 16-byte Tx and Rx FIFO depths.
Three full-duplex Q-SPIs with four slave-select lines; 16 bits wide; 8 locations
deep; Tx FIFO and Rx FIFO.
Four 32-bit timers each containing four capture-and-compare registers linked to
I/Os.
32-bit watchdog with timer change protection, running on safe clock.
108 general-purpose I/O pins with programmable pull-up, pull-down or bus
keeper.
Vectored Interrupt Controller (VIC) with 16 priority levels.
-
–
–
–
open source platform: GNU C compiler + OpenOCD and Eclipse
Two Tightly Coupled Memories (TCM), 16 kB Instruction (ITCM), 16
kB Data TCM (DTCM).
Two separate internal Static RAM (SRAM) instances; 32 kB SRAM and
16 kB SRAM.
768 kB flash-program memory.
Page 3