WJM3000 TriQuint, WJM3000 Datasheet - Page 4
![no-image](/images/manufacturer_photos/0/6/680/triquint_sml.jpg)
WJM3000
Manufacturer Part Number
WJM3000
Description
RFID Modules & Development Tools 902-928 MHz US ISM EPC Class 1 Gen 2
Manufacturer
TriQuint
Datasheet
1.WJM3000.pdf
(7 pages)
Specifications of WJM3000
Operating Current
1.3 A
Operating Voltage
5 V
Output Power
1 W
Product
RFID Readers
Wireless Frequency
902 MHz to 928 MHz
Modulation
FHSS
Antenna
MMCX
Operating Temperature Range
- 20 C to + 50 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
1067012
Copyright WJ Communications 2007. Subject to change without notice.
All trademarks, trade names, service marks, and logos remain the property of the rightful owners
Interface Connector Pin out
Pin #
1, 2
3,4
5
6
7
8
9
10
11
12
13
14
15
WJ Communications
Name
+5.0 V
GND
N/C
WJM_EN
TX
RX
nRESET
nBL/nPD
STATUS_LED
GPIO1
GPIO2
GPIO3
GPIO4
Description
Power Supply. +5.0V @ 1.3 A
Power Supply Ground Return
No Connect
Active High Power Enable. Grounding this pin shuts off entire module. Minimum logic
high voltage is +2.5V. 5V tolerant. Low impedance driver or a pull up resistor less than
2K required.
3.3V CMOS logic-level UART transmit pin
5V tolerant CMOS logic-level UART receive pin
5V tolerant Active Low Reset Pin. 10K internal pull up, interface with open collector
driver. When held low, WJM draws current but will not respond to commands. If nBL/
nPD is held low as nRESET is brought high, the WJM enters Bootloader mode. If nBL/
nPD is held high as nRESET is brought high, the WJM application starts. This pin can
be left unconnected for minimal hardware configuration. A reset controller may be re-
quired if power supply rise time is slow.
5V tolerant Active Low Bootloader/PowerDown pin. 10K internal pull up, interface with
open collector driver. This pin serves two functions.
This pin can be left unconnected for minimal hardware configuration.
3.3V logic-level 3-state output:
Logic high: OK
Tri-State: Sleep Mode
Logic low: Error
Currently FW configures these pins as outputs, they display various debug and status
signals to LEDs. If unused they can be left un-connected.
1) If this pin is low at the rising edge of nRESET (including power-on), the Boot-
2) Once FW starts, bringing this pin low enables sleep mode. The module will not
loader is activated for writing a new Firmware application (FW). If it is high, FW
starts.
respond to API commands in sleep mode. Keep it high for normal operation.
Next Generation RFID Reader Module
www.wj.com
Based on WJC200 Gen2 RFID reader chipset
04/03/2007
WJM3000 G