II-EVB-361MW-EU-220 Connect One, II-EVB-361MW-EU-220 Datasheet - Page 5
![no-image](/images/no-image-200.jpg)
II-EVB-361MW-EU-220
Manufacturer Part Number
II-EVB-361MW-EU-220
Description
WiFi / 802.11 Modules & Development Tools Eval board for Sec Socket iWiFi MS EU
Manufacturer
Connect One
Datasheet
1.II-EVB-361MW-EU-220.pdf
(15 pages)
Specifications of II-EVB-361MW-EU-220
Interface Type
RS-232
Security
WPA, TKIP, AES-CCM, WEP 64,128 bit
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Installing the II-EVB-361MW Utility
and Evaluation Program
II-EVB-361MW enables you to evaluate the Secure Socket iWiFi without changing
anything in your current development environment. Using a simple terminal program
on a PC, you can issue AT+i commands to the iChip and get responses.
AT+i commands are used to configure parameter values into iChip’s flash memory
and activate Internet tasks such as email send, sockets, FTP sessions, configuration,
and more.
A full description of the AT+i protocol can be found in the AT+i Programmer’s
Manual on the Connect One website in the Documentation section at
http://www.connectone.com.
To help you evaluate the iChip, Connect One supplies the iChip Config Utility. This
is a Windows-based GUI program that contains intuitive dialog boxes to fully
configure iChip. It doesn’t require any knowledge of AT+i commands. It also
contains local firmware upgrade functionality.
The iChip Config Utility also allows you to perform specific Internet communication
tasks such as sending and receiving emails, activating iChip’s websites, entering
SerialNET mode, and more.
The latest iChip Config Utility version and user manual can be found on the
Connect One website at
For more information on the iChip Config Utility and its usage, see the iChip Config
Utility User’s Manual.
II-EVB-361-MW User’s Manual
5. Enter the AT+iRP11 command to obtain a report of all the Access Points
6. Enter AT+iWLSI=<ssid>. ssid is the ID of the Access Point you connect to.
7. If you want to enable WEP encryption, configure the following parameters:
8.
available in your area.
Note that ssid is a case-sensitive string.
AT+iWLWM=<n>
AT+iWLKI=<n> where n is the WEP key index (n=1..4)
AT+iWLK<n>=<keyString>
If you want to enable WPA encryption, configure the following parameter:
AT+iWLPP=<passphrase>
be used in generating the WPA1-PSK encryption key
At this stage a connection to the Access Point is established. To test the
connection, use the iChip Config Utility to perform any activity that requires
network connection such as retrieving a web page, sending an email, or
opening a socket.
key, and n=2 means 128-bit key
keyString is the WEP key string in the n
http://www.connectone.com
where n=0 means no security, n=1 means 64-bit
where n is an index between 1 and 4, and
where passphrase is the pass-phrase to
th
position.
in the Support section.
5