ECG005B-G TriQuint, ECG005B-G Datasheet - Page 4

• Manufacturer Part Number: ECG005B-G
• Description: RF Amplifier DC-4 GHz +18dBm P1dB@1 GHz
• Manufacturer: TriQuint
• Type: General Purpose Amplifierr

Specifications of ECG005B-G

• Mounting Style: SMD/SMT
• Number Of Channels: 1
• Operating Frequency: 4000 MHz
• Noise Figure: 3.3 dB @ 2000 MHz
• Operating Supply Voltage: 4.8 V
• Supply Current: 65 mA (Typ) @ 6 V
• Maximum Operating Temperature: + 160 C
• Minimum Operating Temperature: - 40 C
• Package / Case: SOT-89
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 1066905

WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: [phone] • e-mail: [e-mail] • Web site: www.wj.com, www.TriQuint.com
This package is lead-free/Green/RoHS-compliant. The plating material on the leads is NiPdAu. It is compatible with both lead-free
E005G
XXXX-X
ECG005
InGaP HBT Gain Block
(maximum 260 °C reflow temperature) and leaded (maximum 245 °C reflow temperature) soldering processes.
Outline Drawing
Land Pattern
ECG005B-G Mechanical Information
Specifications and information are subject to change without notice
The component will be marked with an “E005G”
designator with an alphanumeric lot code on the
top surface of the package. The obsolete tin-lead
package is marked with an “E005” designator
followed by an alphanumeric lot code; it may
also have been marked with a “F” designator
followed by a 3-digit numeric lot code.
Tape and reel specifications for this part are
located on the website in the “Application
Notes” section.
ESD Rating: Class 1A
Value:
Test:
Standard:
MSL Rating: Level 3 at +260 °C convection reflow
Standard:
1. Ground / thermal vias are critical for the proper performance of this
2. Add as much copper as possible to inner and outer layers near the
3. Mounting screws can be added near the part to fasten the board to a
4. Do not put solder mask on the backside of the PC board in the
5. RF trace width depends upon the PC board material and
6. Use 1 oz. Copper minimum.
7. All dimensions are in millimeters (inches). Angles are in degrees.
Mounting Config. Notes
device. Vias should use a .35mm (#80 / .0135”) diameter drill and
have a final plated thru diameter of .25 mm (.010”).
part to ensure optimal thermal performance.
heatsink. Ensure that the ground / thermal via region contacts the
heatsink.
region where the board contacts the heatsink.
construction.
MSL / ESD Rating
Product Marking
Passes between 250 and 500V
Human Body Model (HBM)
JEDEC Standard JESD22-A114
JEDEC Standard J-STD-020
Page 4 of 4 January 2008