HR30-7J-12PC(71) Hirose Electric Co Ltd, HR30-7J-12PC(71) Datasheet - Page 10
![CONN JACK 12POS MALE CRIMP](/photos/2/6/20670/hr30-7j-12pc_sml.jpg)
HR30-7J-12PC(71)
Manufacturer Part Number
HR30-7J-12PC(71)
Description
CONN JACK 12POS MALE CRIMP
Manufacturer
Hirose Electric Co Ltd
Series
HR30r
Datasheet
1.HR30-6R-C71.pdf
(12 pages)
Specifications of HR30-7J-12PC(71)
Connector Type
Jack for Male Contacts
Number Of Positions
12
Shell Size - Insert
7
Contact Type
Crimp
Mounting Type
Free Hanging (In-Line)
Fastening Type
Push-Pull
Orientation
Keyed
Shell Material, Finish
Polyphenylene Sulfide
Ingress Protection
IP68 - Dust Tight, Waterproof
Features
Strain Relief
Note
Contacts Not Provided
Product Type
Connectors
Contact Style
Pin (Male)
Shell Style
Jacks
Number Of Contacts
12
Shell Size
7
Mounting Style
Cable
Termination Style
Crimp
Contact Plating
Gold
Cable Diameter
6.2 mm to 7 mm
Current Rating
2 A
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Shell Size, Military
-
Contact Size
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
*HR30-7J-12PC(71)
HR596
HR596
The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
10
BAssembly Procedures
1
2
Thread the back shell, strain relief, seal bushing, spring and push/pull locking collar over the cable as shown above.
Solder type
1. Pre-solder the exposed cable conductors (dia. A). The diameter of the pre-soldered conductors should not exceed 0.7
2. Insert the insulator body over the applicable solder termination fixture.
3. Insert the pre-soldered conductors in the contact soldering pot and solder them in place.
Crimp type
1. Crimp the applicable contact to the stripped conductor. Use correct crimp tools. Verify the dimensions and crimp
2. Insert the contact into the appropriate opening in the insulator body.
3. Verify fully seated position by applying a slight pull force on the conductor. The contact should remain in place.
mm for 6 contact plug and 1.0 mm for 3 contact plug.
Soldering iron temperature should be
configuration.
Re-insert if not seated.
Plug Assembly Sequence
applied for 3-4 second.
Solder type : 3 and 6 pos.
Solder type : 12 pos.
Crimp type : 10 and 12 pos.
2
2 mm
2 mm
-0
-0.5
A
mm
5.5 mm max.
15
10 mm max.
B
20 mm