MIL-22520/7/01 Souriau Connection Technology, MIL-22520/7/01 Datasheet - Page 18
MIL-22520/7/01
Manufacturer Part Number
MIL-22520/7/01
Description
Circular MIL / Spec Connectors CRIMP TOOL FRAME
Manufacturer
Souriau Connection Technology
Series
JBX Seriesr
Type
Crimping Toolr
Datasheet
1.MIL-22520701.pdf
(44 pages)
Specifications of MIL-22520/7/01
Product Type
Tools
Termination Style
Crimp
Cable Diameter
0.7 mm to 0.9 mm, 1.3 mm
Product
Crimping, Stripping & Cutting Tools & Drills
Description/function
Contact Crimping
Wire Gauge Range
28-16
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With
Contacts 0.7 mm to 9 mm, 1.3 mm
JBX Series
Push-Pull Connectors
Wiring & assembly instructions
Straight plug
Cable stripping :
Connector preparation
Contact wiring : crimp contacts
Contact wiring : solder contacts
Connector assembly
Fixed solder contacts 0.5 mm and 0.7 mm
1 - Terminate the bucket contacts
using solder method
see page 21 7
18
engage them into the insert cavities
1 - Solder the conductors to the contact buckets then
Removable solder contacts from 0.9 mm to 2 mm
1 - Select the proper collet . (see page 21 7)
2 - Slide the protective boot the backnut
3 - In case of a screened cable, combs out
1 - Select the proper crimping tool (see page
2 - Adjust the tool selector for the correspon-
3 - Crimp the contacts and then engage
1 - Position 2 half bushes on the insert
2 - Position the collet and the half bushes
3 - Position all the sub-assembly in the
4 - Install the backnut and screw it. Use the
5 - Install the protective boot if exists.
and the collet onto the cable.
the screen and fold back over the collet
.
48) and locator according to the connectors
involved.
ding conductor AWG.
them into the insert cavities till clip
tightening.
making sure that the insert key appears
through window of one bush.
while maintaining the screen. Bush keys
are seated in the collet keying slots.
connector housing making sure to keep
sub-assembly aligned.
two wrenches well positionned on the flats
A and B. Place a wrench to grip flats B, use
the other wrench to tighten the backnut at
the flats A following the torque values on
page 21 7.
till clip holding