ABF.00.250.NTA LEMO, ABF.00.250.NTA Datasheet - Page 42

• Manufacturer Part Number: ABF.00.250.NTA
• Description: RF Connectors ADAPT-BNC(UG88U)COAX
• Manufacturer: LEMO

Specifications of ABF.00.250.NTA

• Body Style: Adapter
• Connector Type: Adapter
• Features: IP rating 50
• Housing Material: Brass
• Length: 11.5 mm
• Mounting Angle: Straight
• Operating Temperature Range: - 55 C to + 260 C
• Rf Series: Between Series
• Product: Adapters
• Gender: Male
• Polarity: Normal
• Shell Plating: Nickel
• Impedance: 50 Ohms
• Termination Style: Quick Connect
• Convert From: LEMO Plug
• Convert To: BNC Receptacle
• Side 1 Rf Series: Lemo 00
• Side 2 Rf Series: BNC
• Side 2 Gender: Jack (Female)
• Adapter Style: Straight
• Body Material: Brass
• Side 1 Gender: Jack (Female)
• Side 1 Polarity: Normal
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Terminating of plugs and straight sockets with cable crimping (crimp contact)
40
Straight plug
Free socket
Fixed socket
nut fixing
®
Crimp
Crimp
®
T ± 0.2
S ± 0.2
L ± 0.2
4
4
4
3
3
1.
2.
2.1 Place crimp ferrule ➀ on the cable. Widen the shield braid.
2.2 Crimp the contact with the LEMO crimping tool using
2.3 Slide the crimp ferrule ➀ onto the shield until it rests against
2.4 Slide the assembly into the connector shell ➃ and screw it
Note: these terminating instructions apply to the following models:
1-2-3-4-8
Cable
group
Cable preparation
First place the bend relief (if to be used) on the cable.
Strip the cable according to dimensions below.
Cable termination
Slide the subassembly ➁ into the cable until the insulator rests
against the dielectric and the cable conductor is visible through
the contact inspection hole.
the square hole (see “Tooling” on page 37).
Gently pull the cable in order to check the crimping.
the crimp backnut of the subassembly ➁. Crimp with the same
LEMO crimping tool using the hexagonal opening.
Slide the insulator ➂ onto the subassembly ➁.
onto the subassembly ➁. Tighten using the appropriate tool
to a torque of 0.25 Nm (see “Tooling” on page 35, 36 and 37).
Push the bend relief (if used) onto the crimp ferrule ➀.
6-7
2
2
M4 = FFS, FFV, PCS, PSS, PES
T
7
7
M4
15
15
S
M4
19.5
21.5
L
1
www.lemo.com