L300 Protek, L300 Datasheet - Page 2

• Manufacturer Part Number: L300
• Description: Bench Top Power Supplies 300WATT PROG ELECT LOAD
• Manufacturer: Protek

Specifications of L300

• Output Current (channel 1): 30 A
• Output Voltage (channel 1): 0 VAC to 360 VAC
• Input Voltage: 120 V to 220 V
• Number Of Outputs: 1
• Output Voltage (1): 0 VAC to 360 VAC
• Output Current (1): 30 A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

CAUTION
SAFETY NOTES
of this instrument must be connected to the protective conductor of the AC line
power cord. The AC line plug shall be inserted only in a socket outlet provided
with a negated by the use of an extension cord (or power cable) without a
protective grounding conductor.
phases of operation, service, and repair of this instrument. Failure to comply with
these precautions or with specific warnings elsewhere in this manual violates
safety standards of design, manufacture, and intended use of the instrument. The
Manufacturer assumes no liability for the customer’s failure to comply with these
requirements.
shock hazard, the instrument chassis and cabinet mush be connected to an
electrical ground. The instrument must be connected to the AC Electronic Load
mains through a three-conductor power cable, with the third wire firmly
connected to an electrical ground (safety ground) at the power outlet. For
instruments designed to be hard-wired to the AC power lines, connect the
protective ground terminal to a protective conductor before any other connection
is made. Any interruption of the ground conductor or disconnection of the
protective ground terminal will cause a potential shock hazard that could result in
personal injury. If the instrument is to be energized via an external
autotransformer for voltage reduction, be certain that the autotransformer
common terminal is connected to the neutral of the AC power lines..
replacement and internal adjustments must be made by a qualified service
personnel. Do not touch components with power cable connected. Under certain
conditions, dangerous voltages may exist even with the power cable removed. To
avoid injuries, always disconnect power, discharge circuits and remove external
voltage sources before touching components. Do not substitute parts or modify
the Instrument in any way that may introduce additional hazards. Do not install
substitute parts or perform any unauthorized modification to the instrument.
Return the instrument to a qualified dealer for service and repair to ensure that
safety features are maintained.
Grounding the Instrument
This product is provided with a protective ground terminal. To minimize
Keep Away From Live Circuits
Operating personnel must not remove instrument covers. Component
Before switching on the DC Electronic load, the protective earth terminal
The following general safety precautions must be observed during all
2