GCM188L81H104KA57D Murata Electronics North America, GCM188L81H104KA57D Datasheet - Page 58
![no-image](/images/manufacturer_photos/0/4/466/murata_electronics_north_america_sml.jpg)
GCM188L81H104KA57D
Manufacturer Part Number
GCM188L81H104KA57D
Description
CAP CER 0.1UF 50V X8L SMD
Manufacturer
Murata Electronics North America
Series
GCMr
Datasheet
1.GCM0335C1ER30CD03D.pdf
(66 pages)
Specifications of GCM188L81H104KA57D
Voltage - Rated
50V
Lead Style
*
Capacitance
0.1µF
Tolerance
±10%
Temperature Coefficient
X8L
Mounting Type
*
Operating Temperature
-55°C ~ 150°C
Applications
Automotive
Ratings
AEC-Q200
Package / Case
*
Size / Dimension
*
Thickness
*
Lead Spacing
*
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Features
-
3
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
56
4. Test Condition for AC Withstanding Voltage
(1) Test Equipment
(2) Voltage Applied Method
FAILURE TO FOLLOW THE ABOVE CAUTIONS MAY
RESULT, WORST CASE, IN A SHORT CIRCUIT AND
CAUSE FUMING OR PARTIAL DISPERSION WHEN THE
PRODUCT IS USED.
!Caution
Tests for AC withstanding voltage should be made with
equipment capable of creating a wave similar to a
50/60 Hz sine wave.
If the distorted sine wave or overload exceeding the
specified voltage value is applied, a defect may be
caused.
The capacitor's leads or terminals should be firmly
connected to the output of the withstanding voltage test
equipment, and then the voltage should be raised from
near zero to the test voltage. If the test voltage is applied
directly to the capacitor without raising it from near zero,
it should be applied with the zero cross*. At the end of the
test time, the test voltage should be reduced to near zero,
and then the capacitor's leads or terminals should be
taken off the output of the withstanding voltage test
equipment. If the test voltage is applied directly to the
capacitor without raising it from near zero, surge voltage
may occur and cause a defect.
*ZERO CROSS is the point where voltage sine wave
pass 0V.
- See the figure at right -
Continued from the preceding page.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
0V
Voltage sine wave
zero cross
C03E.pdf
10.5.20