RT8251GSP Richtek USA Inc, RT8251GSP Datasheet - Page 3

• Manufacturer Part Number: RT8251GSP
• Description: IC DCDC CTRLR STP-DN 8SOP
• Manufacturer: Richtek USA Inc
• Type: Step-Down (Buck)r

Specifications of RT8251GSP

• Internal Switch(s): Yes
• Synchronous Rectifier: Yes
• Number Of Outputs: 1
• Voltage - Output: 0.8 V ~ 15 V
• Current - Output: 5A
• Frequency - Switching: 570kHz
• Voltage - Input: 4.75 V ~ 24 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (0.154", 3.90mm Width) Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Functional Pin Description
DS8251-01 March 2011
17 (Exposed Pad)
WQFN-16L 3x3
10, 11, 12, 13,
1, 2, 3, 15, 16
14
4,
5
6
7
8
9
Pin No.
9 (Exposed Pad)
(Exposed Pad)
SOP-8
4,
2
5
6
7
8
1
3
VIN
GND
Pin Name
FB
COMP
EN
SS
BOOT
SW
Power Input Pin. VIN supplies the power to the IC, as well as the
step-down converter switches. Connect VIN with a 4.75V to 24V
power source. Connect VIN to GND with a capacitor that the
capacitance is large enough to eliminate noise on the input to the
IC.
Ground. This pin is the voltage reference for the regulated output
voltage. For this reason, care must be taken in its layout. This
node should be placed outside of the D1 to C
prevent switching current spikes from inducing voltage noise into
the part. The exposed pad must be soldered to a large PCB and
connected to GND for maximum power dissipation.
Feedback Input. An external resistor divider from the output to
GND, tapped to the FB pin, sets the output voltage.
Compensation
transconductance error amplifier and the input to the current
comparator. Frequency compensation is done at this node by
connecting a series R-C to ground.
Enable Input. EN is a digital input that turns the regulator on or
off. Drive EN higher than 1.4V to turn on the regulator, lower
than 0.4V to turn it off. For automatic startup, leave EN
unconnected.
Soft-Start Control Input. SS controls the soft start period.
Connect a capacitor ( ≧ 10nF) from SS to GND to set the
soft-start period. A 10nF capacitor sets the Soft-Start period to
1ms.
Bootstrap. This capacitor C
switch’s gate above the supply voltage. It is connected between
the SW and BS pins to form a floating supply across the power
switch driver. The voltage across C
supplied by the internal +5V supply when the SW pin voltage is
low.
Power Switching Output. SW is the switching node that supplies
power to the output. Connect the output LC filter from SW to the
output load. Note that a capacitor is required from SW to BOOT
to power the high-side switch.
Node. This
Pin Function
BOOT
node
is needed to drive the power
BOOT
is
the output of the
is about 5V and is
IN
RT8251
ground path to
www.richtek.com
3