2154018-6 TE Connectivity, 2154018-6 Datasheet
2154018-6
Specifications of 2154018-6
Related parts for 2154018-6
2154018-6 Summary of contents
Page 1
... Right-Angle Connector ©2011 Tyco Electronics Corporation Connectivity Ltd. Company All Rights Reserved *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. NEVALO* Interconnect System Straight Connector SMT Clip Stripes for Proper ...
Page 2
Bus-to-Wire Connector 2. REFERENCE MATERIAL 2.1. Revision Summary • Updated document to corporate requirements • Added new artwork to Figures and 11 • Changed, added, or deleted text in Section 1, INTRODUCTION; Paragraphs 3.7, 3.8, 3.9, ...
Page 3
C. Chemical Exposure Do not store connectors near any chemicals listed below as they may cause stress corrosion cracking in the contacts. Alkalies Ammonia Citrates Amines Carbonates Nitrites 3.3. Materials The NEVALO housings are made from glass-filled PBT, while the ...
Page 4
Product Selection All NEVALO Interconnects should be used with corresponding colored ribbon cable, light modules, and drivers. Right/left, up/down orientation corresponds to connector orientation relative to NEVALO ribbon cable stripe. Figure 3 shows proper connector orientation third ...
Page 5
NEVALO SMT Clip NEVALO Driver Header 2.50 ± 1.15 0.05 0. 2.80 9.85 -C- ± 1.70 0.05 0. Rev B -B- 1. 1.65 2X 3.00 2X 6.90 2X Figure ...
Page 6
Soldering Observe guidelines and procedures when soldering contacts. Solder, clean, and dry all leads to contacts according to the following. The connectors should be soldered using vapor phase reflow (VPR), double-sided, non-focused infrared (IR), forced air convection, or equivalent ...
Page 7
SOLDERING PROCESS IR The lead-free reflow profile is shown in Figure 7. 3.10. Connector Placement A. Position Optimally, the clip solder feet should be centered on the pads; ever, slight misalignment is permissible. Refer to Figure 8. The pegs of ...
Page 8
B. Seating Force It is imperative that the clip solder feet are sufficiently pressed into the solder paste. 3.11. Terminated Connector Requirements Prepared cable shall be terminated according to the procedures given in the applicable tooling instructions. See Section 5, ...
Page 9
NEVALO Interconnect System. Hand crimping tools are designed for prototype and low-volume applications. Instruction sheets covering tool setup and operation. See Figure 10. CONNECTOR TYPE DIE SET Feed-Thru Multi-Nest Straight 2161080-1 Terminator Right-Angle Right-Angle ...
Page 10
VISUAL AID The illustration below shows a typical application of this product. This illustration should be used by production personnel to ensure a correctly applied product. Applications which DO NOT appear correct should be inspected using the information in ...
Page 11
ALL LATCHES SHOULD BE FULLY CLOSED NOT FULLY CLOSED Rev B FIGURE 11. VISUAL AID (CONT’D) 114-13290 FULLY CLOSED ...
Page 12
Care must be taken when mating or CAUTION unmating connectors to/from clip. ! Rev B FIGURE 11. VISUAL AID (END) 114-13290 CLIP LATCH MUST BE FULLY CLOSED PAST HOUSING BUMP ...