AC164138-1 Microchip Technology, AC164138-1 Datasheet - Page 11

• Manufacturer Part Number: AC164138-1
• Description: CARD DAUGHTER AUDIO PICTAIL
• Manufacturer: Microchip Technology
• Series: PICtail™ Plusr

Specifications of AC164138-1

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: *
• Primary Attributes: *
• Secondary Attributes: *
• Data Bus Width: 8 bit
• Interface Type: SPI
• Operating Supply Voltage: 3.3 V
• Mcu Supported Families: Piccolo
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.1
2.2
© 2011 Microchip Technology Inc.
INTRODUCTION
PLUGGING INTO THE PIC18 EXPLORER BOARD
The MRF89XAMxA PICtail/PICtail Plus Daughter Board can be plugged into multiple
Microchip Technology demonstration and development boards. This allows the
developer to choose the microcontroller that best suits the customer’s development
environment.
The PICtail connector right-angle header, P2, can be plugged into the PIC18 Explorer
Development Board (DM183032). The PICtail Plus card-edge connector, P1, can be
plugged into Explorer 16 Development Board (DM240001).
This chapter describes how the daughter board is plugged into the PIC18 Explorer and
Explorer 16 Development Boards.
The MRF89XAMxA PICtail/PICtail Plus Daughter Board can be plugged into the PIC18
Explorer Board PICtail connector, J3, as shown in Figure 2-1. Make sure to align pin 1
to RE2 as shown.
2.2.1
On the PIC18 Explorer Board, push button switch S2 is normally connected to I/O port
pin RA5. RA5 is not an interrupt-on-change or external interrupt capable I/O pin.
Jumpering JP3 with a shunt allows the connection of RA5 to RB2/INT2 to allow push
button switch S2 to trigger an interrupt. Remember that RB2 also connects to pin 10
(input) of U6 (RS232 level shifter), which is a Clear-to-Send (CTS) signal on P2 pin 8
(DE9 receptacle).
Ensure that the PIC18F87J11 PIM is plugged into the PIC18 Explorer Board. This
sets the system V
PICtail/PICtail Plus Daughter Board.
Chapter 2. Getting Started
Configuring Push Button Switch S2 to RB2/INT2
DD
voltage to 3.3 volts, which is required by the MRF89XAMxA
MRF89XAMxA PICtail™/PICtail
PLUS DAUGHTER BOARD
CAUTION
USER’S GUIDE
DS70653A-page 11