CS5361-KZ Cirrus Logic Inc, CS5361-KZ Datasheet - Page 20

• Manufacturer Part Number: CS5361-KZ
• Description: IC, ADC, 24BIT, 192KSPS, TSSOP-24
• Manufacturer: Cirrus Logic Inc

Specifications of CS5361-KZ

• Resolution (bits): 24bit
• Sampling Rate: 192kSPS
• Input Channel Type: Differential
• Data Interface: Serial
• Supply Voltage Range - Analog: 4.75V To 5.25V
• Supply Current: 22mA
• Digital Ic Case Style: TSSOP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5.0 PARAMETER DEFINITIONS
Dynamic Range
Total Harmonic Distortion + Noise
Frequency Response
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
Offset Error
20
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth. Dynamic Range is a signal-to-noise ratio measurement over the specified bandwidth made
with a -60 dBFS signal. 60 dB is added to resulting measurement to refer the measurement to full-scale.
This technique ensures that the distortion components are below the noise level and do not affect the
measurement. This measurement technique has been accepted by the Audio Engineering Society,
AES17-1991, and the Electronic Industries Association of Japan, EIAJ CP-307. Expressed in decibels.
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels. Measured
at -1 and -20 dBFS as suggested in AES17-1991 Annex A.
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response
at 1 kHz. Units in decibels.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with no signal to the input under test and a full-scale signal applied to the other channel. Units in
decibels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
The deviation of the mid-scale transition (111...111 to 000...000) from the ideal. Units in mV.
CS5361
DS467F2