FT245RL FTDI, FT245RL Datasheet - Page 24

• Manufacturer Part Number: FT245RL
• Description: IC, USB FIFO INTERFACE, SSOP-28
• Manufacturer: FTDI

Specifications of FT245RL

• Data Rate: 1Mbps
• Supply Voltage Range: 1.8V To 5.25V, 3.3V To 5.25V
• Operating Temperature Range: -40°C To +85°C
• Digital Ic Case Style: SSOP
• No. Of Pins: 28
• Termination Type: SMD
• Ic Generic Number: 245
• Filter Terminals: SMD
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

10. Internal EEPROM Configuration
Following a power-on reset or a USB reset the FT245R will scan its internal EEPROM and read the USB configuration
descriptors stored there. The default values programmed into the internal EEPROM in a brand new device are defined
in Table 19.
Table 19 - Default Internal EEPROM Configuration
The internal EEPROM in the FT245R can be programmed over USB using the utility program MPROG. MPROG can
be downloaded from the
their own USB Vendor ID but who would like to use a unique Product ID in their design can apply to FTDI for a free
block of unique PIDs. Contact
FT245R USB UART I.C. Datasheet Version 1.05
Parameter
USB Vendor ID (VID)
USB Product ID (PID)
Serial Number Enabled?
Serial Number
Pull Down I/O Pins in USB Suspend
Manufacturer Name
Manufacturer ID
Product Description
Max Bus Power Current
Power Source
Device Type
USB Version
Remote Wake up
High Current I/Os
Load VCP Driver
FTDI
FTDI support
website. Version 2.8a or later is required for the FT245R chip. Users who do not have
FT245R USB FIFO
Bus Powered
See Note
Disabled
Disabled
FT245R
Enabled
Enabled
Value
for this service.
0403h
6001h
90mA
FTDI
0200
Yes
FT
Enabling this option will make the device pull down on the FIFO interface
A unique serial number is generated and programmed into the EEPROM
Enables the high drive level on the FIFO data bus and control I/O pins
Returns USB 2.0 device descriptor to the host. Note: The device is be
a USB 2.0 Full Speed device (12Mb/s) as opposed to a USB 2.0 High
Taking RXF# low will wake up the USB host controller from suspend.
Makes the device load the VCP driver interface for the device.
lines when the power is shut off (PWREN# is high)
© Future Technology Devices International Ltd. 2005
Speed device (480Mb/s).
during device final test.
FTDI default VID (hex)
FTDI default PID (hex)
Serial number prefix
Notes