AM29F010B-55EF Spansion Inc., AM29F010B-55EF Datasheet - Page 18
![IC, FLASH, 1MBIT, 55NS, TSOP-32](/photos/19/5/190511/4434963_sml.jpg)
AM29F010B-55EF
Manufacturer Part Number
AM29F010B-55EF
Description
IC, FLASH, 1MBIT, 55NS, TSOP-32
Manufacturer
Spansion Inc.
Datasheet
1.AM29F010B-70JF.pdf
(33 pages)
Specifications of AM29F010B-55EF
Memory Type
Flash
Memory Size
1Mbit
Memory Configuration
128K X 8
Access Time
55ns
Supply Voltage Range
4.5V To 5.5V
Memory Case Style
TSOP
No. Of Pins
32
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
AM29F010B-55EF
Manufacturer:
AD
Quantity:
1 500
grammed to “0.” Only an erase operation can change
a “0” back to a “1.” Under this condition, the device
halts the operation, and when the operation has ex-
ceeded the timing limits, DQ5 produces a “1.”
Under both these conditions, the system must issue the
reset command to return the device to reading array
data.
DQ3: Sector Erase Timer
After writing a sector erase command sequence, the
system may read DQ3 to determine whether or not an
erase operation has begun. (The sector erase timer
does not apply to the chip erase command.) If addi-
tional sectors are selected for erasure, the entire time-
out also applies after each additional sector erase com-
mand. When the time-out is complete, DQ3 switches
from “0” to “1.” The system may ignore DQ3 if the sys-
tem can guarantee that the time between additional
Notes:
1. DQ7 requires a valid address when reading status information. Refer to the appropriate subsection for further details.
2. DQ5 switches to ‘1’ when an Embedded Program or Embedded Erase operation has exceeded the maximum timing limits.
16
Standard
Mode
Erase
Suspend
Mode
See “DQ5: Exceeded Timing Limits” for more information.
Embedded Program Algorithm
Embedded Erase Algorithm
Reading within Erase Suspended Sector
Reading within Non-Erase Suspended Sector
Operation
Table 5. Write Operation Status
D A T A
S H E E T
sector erase commands will always be less than 50 μs.
See also the “Sector Erase Command Sequence”
section.
After the sector erase command sequence is written,
the system should read the status on DQ7 (Data# Poll-
ing) or DQ6 (Toggle Bit I) to ensure the device has
accepted the command sequence, and then read DQ3.
If DQ3 is “1”, the internally controlled erase cycle has
begun; all further commands are ignored until the
erase operation is complete. If DQ3 is “0”, the device
will accept additional sector erase commands. To en-
sure the command has been accepted, the system
software should check the status of DQ3 prior to and
following each subsequent sector erase command. If
DQ3 is high on the second status check, the last com-
mand might not have been accepted. Table 5 shows
the outputs for DQ3.
(Note 1)
DQ7#
DQ7
Data
0
1
No toggle
Toggle
Toggle
DQ6
Data
Am29F010B_00_C10 November 12, 2009
(Note 2)
DQ5
Data
0
0
0
DQ3
Data
N/A
N/A
1