LM2596S-5.0 National Semiconductor, LM2596S-5.0 Datasheet - Page 9

• Manufacturer Part Number: LM2596S-5.0
• Description: DC/DC Converter IC
• Manufacturer: National Semiconductor

Specifications of LM2596S-5.0

• Input Voltage: 40V
• Output Current: 3A
• Output Voltage: 5V
• No. Of Pins: 5
• Termination Type: SMD
• Mounting Type: Through Hole
• Voltage Regulator Type: Buck Switching
• Output Current Max: 3A
• Dc To Dc Converter Type: Inverting/Step Down
• Number Of Outputs: 1
• Pin Count: 5 +Tab
• Switching Freq: 173kHz
• Efficiency: 80%
• Package Type: TO-263
• Output Type: Fixed
• Switching Regulator: Yes
• Mounting: Surface Mount
• Input Voltage (min): 4.5V
• Operating Temp Range: -40C to 125C
• Operating Temperature Classification: Automotive
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Test Circuit and Layout Guidelines
where V
Select R
C
C
D1
L1
R1
C
As in any switching regulator, layout is very important. Rap-
idly switching currents associated with wiring inductance can
generate voltage transients which can cause problems. For
minimal inductance and ground loops, the wires indicated by
heavy lines should be wide printed circuit traces and
should be kept as short as possible. For best results,
external components should be located as close to the
switcher lC as possible using ground plane construction or
single point grounding.
If open core inductors are used, special care must be
taken as to the location and positioning of this type of induc-
tor. Allowing the inductor flux to intersect sensitive feedback,
lC groundpath and C
IN
OUT
FF
— 68 µH, L38
— 5A, 40V Schottky Rectifier, 1N5825
— 1 k , 1%
— 470 µF, 50V, Aluminum Electrolytic Nichicon “PL Series”
— See Application Information Section
— 220 µF, 35V Aluminum Electrolytic, Nichicon “PL Series”
REF
1
to be approximately 1 k , use a 1% resistor for best stability.
= 1.23V
OUT
wiring can cause problems.
FIGURE 1. Standard Test Circuits and Layout Guides
Adjustable Output Voltage Versions
(Continued)
9
When using the adjustable version, special care must be
taken as to the location of the feedback resistors and the
associated wiring. Physically locate both resistors near the
IC, and route the wiring away from the inductor, especially an
open core type of inductor. (See application section for more
information.)
01258323
www.national.com