LM2940CS-15 National Semiconductor, LM2940CS-15 Datasheet - Page 13

• Manufacturer Part Number: LM2940CS-15
• Description: Linear Voltage Regulator IC
• Manufacturer: National Semiconductor

Specifications of LM2940CS-15

• No. Of Pins: 3
• Output Current: 1A
• Termination Type: SMD
• Mounting Type: Through Hole
• Voltage Regulator Type: LDO Linear
• Peak Reflow Compatible (260 C): No
• Current Rating: 1A
• Output Voltage Max: 15V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Equivalent Schematic Diagram
Application Hints
EXTERNAL CAPACITORS
The output capacitor is critical to maintaining regulator sta-
bility, and must meet the required conditions for both ESR
(Equivalent Series Resistance) and minimum amount of ca-
pacitance.
MINIMUM CAPACITANCE:
The minimum output capacitance required to maintain sta-
bility is 22 µF (this value may be increased without limit).
Larger values of output capacitance will give improved tran-
sient response.
ESR LIMITS:
The ESR of the output capacitor will cause loop instability if
it is too high or too low. The acceptable range of ESR plotted
versus load current is shown in the graph below. It is essen-
tial that the output capacitor meet these requirements,
or oscillations can result.
13
It is important to note that for most capacitors, ESR is
specified only at room temperature. However, the designer
must ensure that the ESR will stay inside the limits shown
over the entire operating temperature range for the design.
For aluminum electrolytic capacitors, ESR will increase by
about 30X as the temperature is reduced from 25˚C to
−40˚C. This type of capacitor is not well-suited for low tem-
perature operation.
Solid tantalum capacitors have a more stable ESR over
temperature, but are more expensive than aluminum elec-
trolytics. A cost-effective approach sometimes used is to
Output Capacitor ESR
FIGURE 1. ESR Limits
00882206
www.national.com
00882201