LSTD1R IDEC, LSTD1R Datasheet - Page 11

• Manufacturer Part Number: LSTD1R
• Description: SWITCH COMPONENT
• Manufacturer: IDEC

Specifications of LSTD1R

• For Use With: AP6S Series Miniature Pilot Lights
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

•
Replacing Lens and Marking Plate
•
Remove the operator (color lens, marking plate, and lens holder)
by holding the color lens recesses with the Lens Removal Tool
(MT-101) and pulling it out. Remove the marking plate by
disengaging the latches between the color lens and lens holder.
The marking plate must be engraved on the front side as shown
below.
•
Place the marking plate on the lens holder in the correct direction
and press the color lens onto the lens holder to engage the latches.
Insert the lens holder into the housing in the correct direction.
Marking Plate and Engraving Area
Engraving must be made on the engraving area less than 0.5mm deep.
Notes on Mounting
•
•
•
•
14
ø16
Turn off power to the AP6S series units before installation, re-
moval, wiring, maintenance, and inspection. Failure to turn power
off may cause electrical shocks or fire hazard.
Round
Square
Rectangular
Because screw terminal types use hexagonal nuts, they cannot
be mounted closely together. However, rectangular units can be
mounted closely when installed horizontally.
When removing the hexagonal nuts, loosen the the terminal
screws. The hexagonal nuts cannot be removed when the termi-
nal screws are tightened.
When mounting the pilot lights collectively, note the mounting
order. Pilot lights mounted in between units cannot be removed.
Removal
Installation
Screw Terminal
Safety Precautions
Instructions
Shape
AP6S
Color Lens
(polyarylate)
Grooves
Engrraving
Surface
Series
13.8×19.8 mm
Fitting Grooves
Marking Plate
ø13.8 mm
13.8 mm
Size
(acryl)
Miniature Pilot Lights
Lens Holder
(polyarylate)
Waterproof Gasket
(silicon rubber)
Engraving Area
1×18 mm
ø1 mm
1 mm
•
•
The locking ring is plastic. To tighten the ring, use an optional
locking ring wrench (MT-001). Do not use pliers. Do not tighten
with excessive force, otherwise the locking ring will be damaged.
Tightening torque should not exceed 0.88 N·m
•
Collective mounting or continuous illumination of pilot lights may
cause the ambient temperature to rise above the rated operating
temperature. Make sure to provide efficient ventilation when the
mounting panel is not metallic or when the pilot lights are mounted
collectively.
Wiring
Solder the terminal at 350°C within 3 seconds using a 60W
soldering iron. SnAgCu type lead-free solder is recommended.
When soldering, do not touch the pilot light housing with the
soldering iron. Also ensure that no tensile force is applied to the
terminal. Do not bend the terminal or apply excessive force to the
terminal.
Power Supply for LED Lamps
The operating voltage of the LED lamp is within ±5% or ±10% of
the rated voltage. Make sure that the power voltage is within this
range.
For wiring, use wires of proper size to meet the voltage and cur-
rent requirements. Improper soldering may cause overheating and
create fire hazards.
Tab Terminal
Collective Mounting and Continous Illumination
(07/03/26)