US1881LSE Melexis Inc, US1881LSE Datasheet - Page 8

• Manufacturer Part Number: US1881LSE
• Description: IC LATCH CMOS MP TSOT23-3
• Manufacturer: Melexis Inc
• Type: Bipolar Latchr

Specifications of US1881LSE

• Sensing Range: 9.5mT Trip, -9.5mT Release
• Voltage - Supply: 3.5 V ~ 24 V
• Current - Supply: 5mA
• Current - Output (max): 50mA
• Output Type: Digital, Open Drain
• Operating Temperature: -40°C ~ 150°C
• Package / Case: TSOT-23-3, TSOT-3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Other names: US1881LSETR

13 Application Information
13.1 Typical Three-Wire Application Circuit
13.3 Automotive and Harsh, Noisy Environments
14 Application Comments
For proper operation, a 100nF bypass capacitor should be placed as close as possible to the device between
the V
For reverse voltage protection, it is recommended to connect a resistor or a diode in series with the V
When using a resistor, three points are important:
When using a diode, a reverse current cannot flow and the voltage drop is almost constant (≈0.7V).
Therefore, a 100Ω/0.25W resistor for 5V application and a diode for higher supply voltage are recommended.
Both solutions provide the required reverse voltage protection.
When a weak power supply is used or when the device is intended to be used in noisy environment, it is
recommended that figure 13.3 from the Application Information section is used.
The low-pass filter formed by R1 and C1 and the zener diode Z1 bypass the disturbances or voltage spikes
occurring on the device supply voltage V
3901001881
Rev 015
DD
Three-Wire Circuit
and ground pin.
- the resistor has to limit the reverse current to 50mA maximum (V
- the resulting device supply voltage V
- the resistor has to withstand the power dissipated in reverse voltage condition (P
DD
. The diode D1 provides additional reverse voltage protection.
DD
Page 8 of 12
has to be higher than V
Hall Latch – High Sensitivity
13.2 Two-Wire Circuit
Note:
With this circuit, precise ON and OFF
currents can be detected using only two
connecting wires.
The resistors RL and Rb can be used to
bias the input current. Refer to the part
specifications for limiting values.
B
B
DD
RP
OP
CC
min (V
:
:
/ R1 ≤ 50mA)
I
I
OFF
ON
DD
= I
= I
= V
OFF
R
+ I
CC
+ I
US1881
D
DD
– R1.I
OUT
= V
= V
= I
CC
Data Sheet
Jan/06
DD
DD
OFF
2
/R
)
/ R1)
+ V
b
DD
+ I
DD
pin.
DD
/R
L