B57891M472K EPCOS Inc, B57891M472K Datasheet - Page 17

• Manufacturer Part Number: B57891M472K
• Description: THERMISTOR NTC 4.7K OHM 10% RAD
• Manufacturer: EPCOS Inc
• Series: B57891r
• Type: NTCr

Specifications of B57891M472K

• Resistance In Ohms @ 25°c: 4.7K
• Resistance Tolerance: ±10%
• B Value Tolerance: ±3%
• B25/100: 3980K
• Operating Temperature: -40°C ~ 125°C
• Power - Max: 200mW
• Lead Length: 1.42" (36.00mm)
• Mounting Type: PCB, Through Hole
• Package / Case: Molded Disc
• Resistance: 4.7 KOhms
• Tolerance: 10 %
• Termination Style: Radial
• Operating Temperature Range: - 40 C to + 125 C
• Dimensions: 3.5 mm Dia. x 36 mm L
• Lead Spacing: 2.5 mm
• Power Rating: 200 mW
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• B0/50: -
• B25/50: -
• B25/75: -
• B25/85: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: B57891M 472K; B57891M0472K000

Bending strength: Test Ub:
Torsional strength: Test Uc: severity 2
When subjecting leads to mechanical stress, the following should be observed:
Tensile stress on leads
During mounting and operation tensile forces on the leads are to be avoided.
Bending of leads
Bending of the leads directly on the thermistor body is not permissible.
A lead may be bent at a minimum distance of twice the wire's diameter +2 mm from the solder
joint on the thermistor body. During bending the wire must be mechanically relieved at its outlet.
The bending radius should be at least 0.75 mm.
Twisting of leads
The twisting (torsion) by 180 of a lead bent by 90 is permissible at 6 mm from the bottom of the
thermistor body.
4
When thermistors are sealed, potted or overmolded, there must be no mechanical stress caused
by thermal expansion during the production process (curing / overmolding process) and during
later operation. The upper category temperature of the thermistor must not be exceeded. Ensure
that the materials used (sealing / potting compound and plastic material) are chemically neutral.
5
If cleaning is necessary, mild cleaning agents such as ethyl alcohol and cleaning gasoline are
recommended. Cleaning agents based on water are not allowed. Ultrasonic cleaning methods are
permissible.
6
In order to maintain their solderability, thermistors must be stored in a non-corrosive atmosphere.
Humidity, temperature and container materials are critical factors.
Do not store SMDs where they are exposed to heat or direct sunlight. Otherwise, the packing ma-
terial may be deformed or SMDs may stick together, causing problems during mounting. After
opening the factory seals, such as polyvinyl-sealed packages, use the SMDs as soon as possible.
Please read Cautions and warnings and
Important notes at the end of this document.
Temperature measurement and compensation
Leaded NTC thermistors, lead spacing 2.5 mm
Sealing and potting
Cleaning
Storage
Two 90 -bends in opposite directions at a weight of 0.25 kg.
The lead is bent by 90 at a distance of 6 to 6.5 mm from the thermistor body.
The bending radius of the leads should be approx. 0.75 mm. Two torsions of
180 each (severity 2).
Page 17 of 23
B57891M
M891