EK-H2 SENSIRION, EK-H2 Datasheet - Page 3
![Sensor Evaluation Kit](/photos/19/83/198344/4612614_sml.jpg)
EK-H2
Manufacturer Part Number
EK-H2
Description
Sensor Evaluation Kit
Manufacturer
SENSIRION
Datasheet
1.EK-H2.pdf
(7 pages)
Specifications of EK-H2
Kit Contents
2 Type SHT11/5, 2 Type SHT 75 Sensors, ASD11 Board, Serial And Sensor Cable, Power Supply
Tool / Board Applications
Humidity And Temperature Sensor
Mcu Supported Families
SHTxx
Development Tool Type
Hardware / Software - Eval/Demo Board
Rohs Compliant
Yes
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
1 What You Need to Get Started
Evaluation Kit EK-H2 for SHTXY
Table 1: Contents of the evaluation kit EK-H2.
Make sure you have all of the following items before you install the hardware and Humiview software for Windows
2000/NT/XP:
If you do not have a CD drive and would like to order the Humiview software on a floppy disk, please contact Sensirion AG.
2 Installing the Hardware
In the following section, all the necessary electrical interconnections for the SHTXY sensor system will be listed. These
connections are required between the SHTXY, the ASD11 microprocessor board, a PC serial interface, and a power supply.
Observe precautions when handling electrostatic sensitive devices!
To install your SHTXY hardware, complete the following steps (see Fig. 2):
www.sensirion.com
(1) sensor systems (2 x SHT11, 2 x SHT15 & 2 x SHT75) + 4x filter cap SF1
(2) sensor interface cable
(3) serial interface cable
(4) power supply
(5) microprocessor board ASD11 (incl. LCD and RS-232 Interface)
(6)
(7)
(8) Adapter
_ Windows 2000/XP or Windows NT version 4.0/SP6.
_ An unused serial interface port (e.g. COM1).
_ Humiview (V 3.0) software for Windows 2000/NT/XP on CD.
_ Contents of your evaluation kit as described in the Introduction.
_ Turn on your PC and start Windows 2000/NT/XP.
_ Connect the serial interface cable with the COM port of your PC (configuration of the
_ Connect the interface cable with the ASD11 microprocessor board using the serial
_ Plug in the power supply. Input 100V - 240V AC, 47Hz - 63Hz.
_ Connect the SHTXY sensor system to the ASD11 microprocessor board using the
Humiview (V3.0) software on CD
Palm software on CD suitable for Palm III & V
serial interface see App. A).
interface connector (pin diagram of the ASD11 is given in App. A).
sensor interface cable.
3/7