D10IPFPQ BANNER ENGINEERING, D10IPFPQ Datasheet - Page 6

• Manufacturer Part Number: D10IPFPQ
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING
• Type: Analog And Discrete Outputr

Specifications of D10IPFPQ

• Sensor Output: PNP
• Sensor Input: Fiber Optic
• Output Type: Transistor
• Contact Current Max: 150mA
• Switch Terminals: Quick Connect
• Fiber Optic Sensor Type: Analog And Discrete Output

• Two-point TEACH to set a single threshold.
• Threshold is adjustable using the “+” and “–” buttons (see Manual Adjust, page 8).
D10 Expert
6
P/N 65448 rev. E
• Press and
• Present Output
• Click Static button.
• Present Output
• Click Static button.
hold Static (-)
button.
ON target.
OFF target.
Push Button
™
Analog and Discrete Outputs
T
T
T
T
• No action required;
• Present Output ON
• Single-pulse the
• Present Output OFF
• Single-pulse the
T
T
sensor is automatically
ready for 1st TEACH condition.
target.
remote line.
target.
remote line.
T
T
T
T
0.04 sec. ≤ T ≤ 0.8 sec.
T
T
Remote
Static TEACH
T
T
T
T
T
T
T
T
• Display flashes “1st”
• Arrow icon turns red
• Display flashes “2nd”
TEACH conditions acceptable:
• Display flashes “pass,” followed
• Sensor returns to RUN mode with
• Arrow icon turns green
TEACH conditions unacceptable:
• Display flashes “fail” and
• Arrow icon remains red
• After 60 seconds, sensor returns
by a number (denoting contrast);
see table below.
new settings.
returns to “1st”
to RUN mode (Arrow icon
turns green) without changing
settings.
500+
100 - 500
32 - 99
0 - 31
Contrast Values
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
Excellent
Good
Low
Marginal
Result
•
Minneapolis, MN U.S.A.