FSS1500NGT Honeywell Sensing and Control, FSS1500NGT Datasheet - Page 3

• Manufacturer Part Number: FSS1500NGT
• Description: Force Sensor
• Manufacturer: Honeywell Sensing and Control

Specifications of FSS1500NGT

• Load Capacity: 1.5kg
• External Depth: 3.18mm
• Input Impedance: 5kohm
• Operating Temperature Range: -40°C To +85°C
• Supply Voltage: 5V
• Sensing Accuracy: 0.7%
• Sensor Output: Voltage
• Supply Voltage Max: 6V
• Sensor Terminals: SMD
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 3. Environmental Specifications
Notes:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. The maximum difference between output readings when the same force is applied consecutively, under the same operating
11. The maximum difference between output readings when the same force is applied consecutively, under the same operating
12. The maximum deviation in Offset due to changes in temperature over the Operating Temperature Range, relative to Offset
13. The maximum deviation in Full Scale Span due to changes in temperature over the Operating Temperature Range, relative to
14. The maximum force which may safely be applied to the product for it to remain in specification once force is returned to the
15. MCTF is a basic measure of reliability for a non-repairable device. It is the mean number of cycles to maximum operating force
Parameter
Shock
Vibration
Mean Cycles To Failure (MCTF)
Absolute maximum ratings are the extreme limits that the device can withstand without damage to the device.
The temperature range over which the product may safely be exposed without excitation or force applied. Under these
conditions the product will remain in specification after excursion to any temperatures in this range. Exposure to temperatures
beyond this range may cause permanent damage to the product.
The maximum temperature and time for which the product can be exposed to for processing of solder electrical connections.
The range of voltage excitation which can be supplied to the product to produce an output which is proportional to Force but
due to Ratiometricity errors may not remain within the specified performance limits.
The temperature range over which the product will produce an output proportional to force but may not remain within the
specified performance limits.
The output signal obtained when the zero force is applied to the sensor. Also known as "null" or "zero".
known as "full scale output" or simply "span".
The ratio of output signal change to the corresponding input force change. Sensitivity is determined by computing the ratio of
Span to the specified Operating Force Range.
Force Non-Linearity (Best Fit Straight Line): The maximum deviation of product output from a straight line fitted to output
measured over the operating force range. The straight line through a set of points which minimizes the sum of the square of
the deviations of each of the points from the straight line.
conditions, with force approaching from the same direction within the operating force range.
conditions, with force approaching from opposite directions within the operating force range.
measured at 25 °C.
Full Scale Span measured at 25 °C.
Operating Force Range. Exposure to higher forces may cause permanent damage to the product. Unless otherwise specified
this applies to all temperature within the Operating Temperature Range.
over which a sensor can be expected to operate until failure. The mean value is determined statistically from a probability
distribution for failures based upon test data. MCTF may vary depending on the specific application in which a sensor is
utilized.
The algebraic difference between output signal measured at the upper and lower limits of the Operating Force Range. Also
15
Characteristics
Qualification tested to 150 G
20 million at 25 ° C [77 ° F]
Qualification tested to 0 to 2 kHz, 20 G sine
Low Profile Force Sensor
Honeywell Sensing and Control
3