QS30EQ BANNER ENGINEERING, QS30EQ Datasheet - Page 4

• Manufacturer Part Number: QS30EQ
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of QS30EQ

• Output Current: 100mA
• Supply Voltage Range Dc: 10V To 30V
• Sensor Housing: Rectangular
• Sensor Input: Optical
• Body Material: ABS
• Supply Voltage Max: 30VDC
• Sensing Range Max: 60m
• Contact Current Max: 40mA

WORLD-BEAM
4
Supply Voltage
Output Configuration
Output Response
Repeatability
Cutoff Point Tolerance
Adjustments
Indicators
Construction
Connections
Operating Conditions
Vibration and Mechanical
Shock
Application Tip for the
QS30LV Model
Certifications
P/N 119165 rev. A
®
10 to 30V dc (10% maximum ripple) at less than 40 mA, exclusive of load;
Protected against reverse polarity and transient voltages
Bipolar: One current sourcing and one current sinking
Rating: 100 mA maximum each output at 25°C
Off-state leakage current: NPN: less than 200 µA
ON-state saturation voltage: NPN: less than 1.6V @ 100 mA
Protected against false pulse on power-up and continuous overload or short circuit of outputs
Opposed Mode: 5 milliseconds ON and OFF
All others: 2 milliseconds
NOTE: 100 millisecond delay on power-up; outputs do not conduct during this time
Opposed Mode: not applicable
All others: 500 microseconds
Fixed-Field only: ± 5% of nominal cutoff distance
Selectable Light/Dark Operate is achieved via the gray wire.
Opposed, Retroreflective, and Polarized Retroreflective models:
Diffuse and Fixed-Field models:
Diffuse, Retroreflective, and Polarized Retroreflective mode models (only):
* Input impedance 10 kΩ
2 LED indicators on sensor top:
Large oval LED indicator on sensor back (except emitters):
ABS housing, rated IEC IP67; NEMA 6; Acrylic lens cover
3 mm mounting hardware included
2 m (6.5') or 9 m (30') 5-wire PVC cable or 5-pin Euro-style integral QD connector
Temperature: -20° to +70° C (-4° to +158° F)
Relative Humidity: 90% @ 50° C (non-condensing)
All models meet Mil. Std. 202F requirements method 201A (vibration: 10 to 60 Hz max., double amplitude 0.06",
maximum acceleration 10G). Also meets IEC 947-5-2; 30G 11 ms duration, half sine wave.
For best sensing reliability, targets should be a minimum of 0.5m from the sensor.
Approvals in process
Green ON steady: Power ON
Green flashing: Output overloaded (except receivers)
Yellow ON steady: Output conducting
QS30 – DC Voltage
Light Operate - Low (0 to 3V)*
Dark Operate - High (open or 5 to 30V)*
Light Operate - High (open or 5 to 30V)*
Dark Operate - Low (0 to 3V)*
Single-turn Sensitivity (Gain) adjustment potentiometer
PNP: less than 10 µA
PNP: less than 2.0V @ 100 mA
Specifications
Yellow ON steady: Light sensed
Yellow flashing: Marginal excess gain
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
(1.0 to 1.5x excess gain)
•
Minneapolis, MN U.S.A.