QS30LDL BANNER ENGINEERING, QS30LDL Datasheet - Page 4

• Manufacturer Part Number: QS30LDL
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of QS30LDL

• Output Current: 150mA
• Sensor Output: NPN/PNP
• Supply Voltage Range Dc: 10V To 30V
• Sensor Housing: Rectangular
• Sensor Input: Laser
• Body Material: ABS Plastic
• Supply Voltage Max: 30VDC
• Sensing Range Max: 800mm

QS30 Series Diffuse-Mode Laser Sensor
Sensor configuration is accomplished through TEACH-mode programming and
SETUP mode. After TEACH mode has defined the sensing parameters, SETUP mode
may be used to add an OFF-delay or change the light/dark operate status. Manual
Adjust may be used to fine-tune the thresholds (see page 7). Two push buttons,
Dynamic (+) and Static (-), or the remote wire, may be used to access and set
programming parameters.
Sensor programming may be accomplished using any of three TEACH methods. A
single switching threshold may be programmed using either dynamic (on-the-fly) or
static TEACH. In addition, Single-Point Static TEACH may be used to define a sensing
window, centered on a single taught condition. Single-Point TEACH programming
may be accomplished only statically.
The Remote Programming function may be used to program the sensor remotely or to
disable the push buttons for security. Connect the gray wire of the sensor to ground
(0V dc), with a remote programming switch connected between them. Pulse the remote
line according to the diagrams in the programming procedures. The length of the
individual programming pulses is equal to the value T:
TEACH and SETUP modes each may be exited either after the 60-second time-out, or
by exiting (cancelling out of) the process:
• In Static TEACH mode, press and hold the Static (-) button (or hold the remote line)
• In SETUP mode, press and hold both the Static (-) and Dynamic (+) buttons (or hold
4
for 2 seconds to exit. The sensor returns to RUN mode without saving any new
settings.
the remote line) for 2 seconds to exit. The sensor returns to RUN mode and saves
the current setting.
Remote Programming
Returning to RUN Mode
P/N 109027 rev. C
0.04 seconds ≤ T ≤ 0.8 seconds
Sensor Programming
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
•
Minneapolis, MN U.S.A.