SMA30SEL BANNER ENGINEERING, SMA30SEL Datasheet - Page 2

• Manufacturer Part Number: SMA30SEL
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of SMA30SEL

• Output Current: 250mA
• Supply Voltage Range Dc: 10V To 30V
• Sensing Range Max: 700ft
• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Sensor Housing: Barrel
• Switch Terminals: Cable

2
Supply Voltage and Current
Supply Protection Circuitry
Output Configuration
Output Rating
Output Protection Circuitry
Output Response Time
Repeatability
Indicators
Construction
Environmental Rating
Connections
Operating Conditions
Certifications
P/N 03541 rev. D
SM30 Series 30 mm Sensors –
102 mm
(4.0")
Cabled Models
Emitters: 12 to 240V ac (50/60 Hz) or 10-30V dc at 20 mA, 10% maximum ripple
DC Receivers: 10 to 30V dc at 10 mA maximum (exclusive of load); 10% maximum ripple
AC Receivers: 24 to 240V ac (50/60 Hz)
Protected against reverse polarity and transient voltages
DC Receivers: Bi-Modal™ output (PNP sourcing or NPN sinking). Selection of light/dark operate and
sourcing or sinking configuration dependent on hookup.
AC Receivers: SPST solid-state switch; light operate (LO) or dark operate (DO) dependent on model.
DC Receivers: 250 mA continuous
Output saturation voltage (PNP & NPN configuration) < 1 volt at 10 mA and < 2 volts at 250 mA
Off-state leakage current < 10 microamps
AC Receivers: Maximum steady-state load capability is 500 mA
Outputs of dc receivers are short circuit protected
10 milliseconds on/off
“A” frequency models: 1 ms
“B” frequency models: 1.5 ms
“C” frequency models: 2.3 ms
Internal red LED, visible through the lens or from side of the sensor.
Emitters: Red “Power ON” indicator LED
DC Receivers: Lights whenever receiver sees its modulated light source
AC Receivers: Lights whenever receiver’s output is conducting
Fully epoxy-encapsulated tubular threaded housing, positive sealed at both ends, quad-ring sealed acrylic lens.
Plastic models: 30 mm diameter thermoplastic polyester housing and jam nuts.
Stainless Steel models: 30 mm diameter 303 stainless steel housing and jam nuts.
Exceeds NEMA 6P and IEC IP67 standards
PVC-jacketed 2 m or 9 m cables or Mini-style quick-disconnect (QD) fitting are available. QD cables are
ordered separately. See page 4.
Temperature: -40° to +70° C (-40° to +158° F)
Relative humidity: 90% at 50° C (non-condensing)
Inrush capability: 10 amps for 1 second (non-repeating)
Off-state leakage: current < 1.7 mA rms
On-state voltage drop: < 3.5 volts rms across a 500 mA load; < 5 volts rms across a 15 mA load
Jam Nuts
(2 Provided)
Alignment
Indicator (Receivers)
M30 x 1.5
Thread
Specifications
Dimensions
for Especially Demanding Applications
114 mm
(4.5")
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
QD Models
Jam Nuts
(2 Provided)
•
Minneapolis, MN U.S.A.
Alignment
Indicator (Receivers)
M30 x 1.5
Thread