XF2M-2015-1A-R100 Omron, XF2M-2015-1A-R100 Datasheet - Page 25

• Manufacturer Part Number: XF2M-2015-1A-R100
• Description: CONNECTOR FPC 20POS 0.3MM SMD
• Manufacturer: Omron
• Series: XF2Mr

Specifications of XF2M-2015-1A-R100

• Connector Type: Top and Bottom Contacts
• Number Of Positions: 20
• Pitch: 0.020" (0.50mm)
• Ffc, Fcb Thickness: 0.30mm
• Height Above Board: 0.083" (2.10mm)
• Mounting Type: Surface Mount, Right Angle
• Cable End Type: Straight
• Termination: Solder
• Locking Feature: Rotary Lock, Backlock
• Contact Finish: Gold
• Contact Finish Thickness: 5.9µin (0.15µm)
• Operating Temperature: -30°C ~ 85°C
• Current Rating: 0.500A
• Voltage Rating: 50V
• Housing Material: Liquid Crystal Polymer (LCP)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Other names: XF2M20151AR100

XF
Operating the XF Rotary Front Lock
FPC Connector Part Names
Handling Methods
Inserting the FPC
1. Use your fingernail on the center of the slider to twist the
slider until it comes away from the unit.
2. Securely insert the FPC so that it is perpendicular to the
connector and horizontal to the connector.
3. When locking the slider, apply pressure with your finger-
tips to the center of the slider, then twist the slider until it
comes away from the unit.
Removing the FPC
1. Unlock the slider by pushing it up, then remove the FPC.
Circuit
board
Terminal
Housing
Slider (lever)
FPC
Precautions during Use
Operating
1. The slider mechanism rotates around a rotary shaft.
2. The slider cannot be opened to an angle of more than
3. Lock and unlock the slider using the center of the slider.
4. As shown in the following figure, do not touch the termi-
5. Using the FPC in the follow ways may damage the FPC,
6. Make sure that the FPC has been inserted correctly and
Change in shape of tip of terminal
Operate the slider in a rotating movement.
125°. Do not apply force on the slider beyond that point.
Doing so may result in damage to the connector or con-
tact failure. Do not use the slider if it becomes detached.
Using the end of the slider may result in incomplete lock-
ing, damage, or contact failure.
nals with your fingernail or fingers if using the slider with-
out the FPC inserted. Doing so may cause the terminals
to change shape and result in contact failure.
change the shape of the contacts, or result in contact fail-
ure.
not backward.
Inserting the FPC incorrectly with the connecting face not
aligned with the customer's design specification may
damage the contacts and equipment may malfunction.
• Removing the FPC when the slider (lever) is still locked.
• Removing the FPC by pulling it up and down or from left
to right or twisting it sideways.
Rotating shaft
125°
Change in shape of
upper arm of terminal
XF
25