130C-1-1/2X30FT 3M, 130C-1-1/2X30FT Datasheet - Page 2

• Manufacturer Part Number: 130C-1-1/2X30FT
• Description: TAPE, SPLICING, RUBBER, BLACK 1.5INX30FT
• Manufacturer: 3M
• Type: Electricalr

Specifications of 130C-1-1/2X30FT

• Tape Backing Material: Rubber
• Roll Length: 30ft
• Tape Type: Electrical Insulation
• Width: 1-1/2"
• Color: Black
• Elongation: 1000%
• Length, Tape: 30 ft.
• Material, Tape: Rubber
• Temperature Rating: +90 °C
• Thickness, Tape: 0.762 mm
• Width, Tape: 1-1⁄2 in.
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

IMPORTANT NOTICE
Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks
and liability associated with such use.
Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture as of the date
of purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated
above, your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M
product. Except where prohibited by law, 3M will not be liable for any loss or damage arising from this 3M product,
whether direct, indirect, special, incidental or consequential regardless of the legal theory asserted.
Electrical Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
www.3M.com/elpd
Volume Resistivity
(ASTM-D-4325)
Dielectric Constant
(ASTM-D-4325)
Dissipation Factor
(ASTM-D-4325)
* All values are averages and are not intended for
specification purposes.
Specification
Product
The high-voltage corona resistant tape must be
supplied without a liner, be based on ethylene
propylene rubber, and be capable of emergency
operating cable temperature of 130˚C. The tape must
be capable of being applied in either stretched or
unstretched conditions without resulting in loss of
either physical or electrical properties. The tape
must not split, crack, slip, or flag when exposed to
various environments (indoor or outdoor). The tape
must be compatible with all synthetic cable
insulations and have a shelf life of five years.
Engineering/Architectural Specification
Splicing and terminating solid dielectric cable shall
be done in accordance with drawings engineered by
the splice material manufacturer, such as the 2047
series available from 3M. All splices and
terminations shall be insulated using Scotch 130C
Electrical Tape.
3M and Scotch are trademarks of 3M.
Aged 96 hrs. @ 23˚C 96% RH
Original
1200 volts @ 60 Hz
23˚C
90˚C
1200 volts @ 60 Hz
23˚C
90˚C
>10
>10
15
14
ohm-cm
ohm-cm
0.70%
3.00%
3.5
3.6
Installation Technique
This tape should be applied in successive half-
lapped level wound layers until desired build-up is
reached. It should be applied like any rubber tape;
that is, the side of the tape wrapped inside the roll
should be applied outside on the splice (tacky side
up). This will help prevent the roll from getting
progressively further away from the work area.
To eliminate voids in critical areas, highly elongate
130C tape. Stretch tape in critical areas just short of
the breaking point; doing so will not alter its
physical or electrical properties. In less critical areas,
less elongation may be used. The tape should be
stretched to a minimum of 3/4 its original width.
Always attempt to half-lap to produce a uniform
buildup. When using 130C tape for splicing cable
above 15 kV, always highly elongate the tape
throughout the entire splice. Techniques for proper
usage of 130C tape are contained in standard and
special prints available though the “3M System for
Splicing and Terminating” program. These are
available through the local 3M Electrical Products
Division representative.
Shelf Life
Scotch
of manufacture) when stored under the following
recommended storage conditions. Store behind
present stock in a clean dry place at a temperature of
70˚F (21˚C) and 40% to 50% relative humidity.
Good stock rotation is recommended.
Availability
Scotch
electrical distributor in the following roll sizes.
®
®
130C Tape has a 5-year shelf life (from date
130C Electrical Tape is available from your
3/4 in. by 30 ft. (19 mm x 9,1 m)
1 in. by 30 ft. (25,4 mm x 9,1 m)
1 1/2 in. by 30 ft. (38 mm x 9,1 m)
2 in. by 30 ft. (50,8 mm x 9,1 m)
©3M IPC 2000 78-8125-9449-3-A
Litho in USA